TEOS MECHANICAL PUSH SYSTEM Lid Hole Diameter: 16 mm Lid Hole Diameter: 40 mm Install the Flushing Unit on the toilet tank lid, matching the hole diameters as seen in the figures. ATTENTION! : Do Not use this component If the Lid Hole is 40mm. Installation to Lid Hole ø16 Installation to Lid Hole ø40 - Install the Flushing Unit as seen. - Position the Large Rubber Seal to the Flush Hole and Install the fixation screws as shown in the figure. Adjust the level of the Flushing Unit by loosing or tightening the component (screw) at the top. There must be 1-2 mm's gap after the adjustment. Visam; due to continuous improvement, shape, color and specifications are subject to change without notification.
© Copyright 2024 Paperzz
