Long Beach Fire
Department
PROSSER PUMP
BASIC SETUP
Components
Main dewatering pump
Junction box
Attached power cord
Additional extention cord
BASIC SETUP
Main unit
The pump can move 300gpm
and pump to a height of 50
feet.
3” hose with 2 1/2 couplings
are used to move water.
A knotted rope is used for
lowering lowering unit.
BASIC SETUP
Junction box
Has a handle for the on/ off
switch.
The junction box also has a
10 ‘ cord to plug in to the
outlets on the fireboat and a
50’ cord that is attached to
the main power unit.
Operations extending past
50’, the 100’ extension cord
can be used.
BASIC SETUP
100’ extension cord is
separate from the main pump
and is hung in the equipment
room.
Basic Set-up
Proser Pump Panel
The port outlet and circuit breaker
panel are located on the portside
bulkhead behind the door leading to
the engine room.
Once the breaker is turned on, the test light will
blink red and must be reset. You must hit the
reset button and the light will switch and show a
solid green light and the pump can be activated.
The 30A 240V outlet is only
used for our prosser pump
connector. Note the 4pronged system...
30A 125V will not
work...
The starboard outlet is
located just outside the pilot
house
Once the breaker is turned on, the test light will
blink red and must be reset. You must hit the reset
button and the light will switch and show a solid
green light and the pump can be activated.
The circuit breaker for the starboard
connection it located in the pilot
house, on the electrical panel.