Reset Form
Well Light C54
120 Volt Copper and Bronze, PAR38 Incand. / Hal., R40 Incand.
revision 11/27/06 • c54.pdf
Approvals:
C54 /
Fixture - assembled with fixture
Option - ordered separately
See page 2
Specifications
UL cUL 15981
IP67 Rated
Date:
Page: 1 of 2
ORDERING INFORMATION
Fixture
C54
Wattage / Lamp
150W
PAR38
Incandescent / Halogen
NT
INU
Housing: Spun copper, bronze clamping ring, prewired cord
through brass seal.
Lens: Convex tempered clear glass with silicone gasket.
Socket: Porcelain medium base.
Well: 9" diameter x 14L" depth direct burial PVC pipe.
Louver: Cast aluminum finished black with polished edges,
secured to well with socket head set screws. Slot sizes
allow light and drainage, and prohibit litter from collecting
in the well, however, not recommended for pedestrian or
walkover traffic.
Junction Box: Die-cast brass, K" rigid conduit and brass seal
for fixture cord, two K" NPT conduit entries in sides, one
K" NPT conduit entry in bottom. 21 cu. in. volume.
ED
Type:
Job:
Fixture Catalog number:
Listings and Ratings
–
CE
Suitable for wet locations
NOTE: Fixture will tilt 15° within well. If greater tilt is needed,
entire well can be installed at an angle.
CAUTION: Not approved for walk-over areas. Conduit entries
must be RTV sealed. Do not submerge. Provide drainage
during installation (by others) to prevent flooding.
CO
1
25C Ambient
ISO 9001:2000
150W
R40
Incandescent
16J"
(412.8 mm)
3L" DIA.
(95.3 mm)
DIS
9K"
(241.3 mm)
High Ground Cover
Rock, Bark, Low
Ground Cover, etc.
(2) K"
NPT
14E"
(377.8 mm)
17" MIN.
(431.8 mm)
Drainage
(by others)
Hubbell
Lighting, Inc.
KIM LIGHTING RESERVES THE RIGHT TO CHANGE SPECIFICATIONS WITHOUT NOTICE.
© 2006 KIM LIGHTING INC. • P.O. BOX 60080, CITY OF INDUSTRY, CA 91716-0080 • TEL: 626/968-5666 • FAX: 626/369-2695
5626306331
Well Light C54
120 Volt Copper and Bronze, PAR38 Incand. / Hal., R40 Incand.
revision 11/27/06 • c54.pdf
Type:
Job:
Fixture Options
9K"
(241.3 mm)
May be ordered separately. To order assembled with fixture, add to
fixture Cat. No. - Example: C54/70MH120/5090DL
Gray cast iron. Designed to mount into the Neenah Foundry
R-8860 93" round tree grate with 9K" diameter light opening. Slotted
design allows light and drainage, and prohibit litter from collecting in
the well, however, not recommended for pedestrian or walkover
traffic. For use with tree grate only.
9K" DIA.
(241.3 mm)
May be ordered separately. To order assembled with fixture, add to
fixture Cat. No. - Example: C54/70MH120/5293TG
DIS
CO
Tree Grate Louver
Cat. No. 5293TG
5293TGAssembled
with fixture
No Option
9K" square. Cast aluminum. Replaces standard full louver. Provides
glare control and allows maximum light output in direction of fixture
tilt. Slot sizes vary to allow light and drainage, and prohibit litter from
collecting in the well, however, not recommended for pedestrian or
walkover traffic.
NT
INU
Directional Louver
Cat. No. 5090DL
5090DLAssembled
with fixture
No Option
ED
Page: 2 of 2
© 2006 KIM LIGHTING INC. • P.O. BOX 60080, CITY OF INDUSTRY, CA 91716-0080 • TEL: 626/968-5666 • FAX: 626/369-2695
5626306331