OPTIMUM COATING SOLUTIONS
OPTEK PRODUCTS
CEMETITIOUS COATINGS AND
ADDITIVES
Brief overveiw
OPTEK-H
• AREAS OF USE
• Restoration of degraded concrete structures (approved
for use on Heritage sites).
• Dust proofing of factory floors.
• Surface hardening and abrasion resistance of concrete
surfaces i.e. floors, roadworks, bridge decks etc.
• Reinstatement of poorly finished concrete.
• Primer for cementitious render.
• Water retention agent for new hardening concrete.
PALLONA DAM TASMANIA
Spillway wall treated with OPTEK H
OPTEK H
SPILLWAY IN USE AFTER COATING
OPTEK H APPLICATION
OPTEK HBT
• OPT-TEK HB-T is a high build thixotropic synthetic fibre reinforced
cement based rheoplastic and non-segregating high strength
mortar.
• OPT-TEK HB-T is a chemical resistant compound with Migrating
Corrosion Inhibitor designed to protect embedded steel
reinforcement and repair damaged or spalling concrete surfaces.
• USES
• OPT-TEK HB-T is used for the structural repair of concrete including:
• Water treatment and sewage facilities
• Marine structures
• Bridges
• Tunnels pipes outfalls and all below ground structures especially in
harsh ground conditions
• Walls, cooling towers chimneys and other concrete repair
applications
HBT Benefits
• BENEFITS
• Can be applied 5mm-50mm in a single layer thickness even in an overhead
application
• Overhead, vertical and horizontal applicable in enclosed or open
environments, wet or dry conditions.
• Excellent workability
• Sulphate resistance
• Shrinkage compensated
• High early and ultimate strengths
• Waterproof, highly impermeable
• Sprayable
• No added chlorides
• Excellent abrasion resistance and durability
• High Freeze/thaw, carbonation and sulphate resistance.
• Product, when correctly applied, has a life greater than 10 years
OPTEK PLUG
• Opt-Tek Plug is a one-component, rapid
hardening plug composition for permanent
stopping of water seepage and pressure leaks
through cracks and construction joints in
concrete, rock, wooden and masonry structures
• Opt-Tek Plug is a chloride free, ready for use grey
powder based on Portland cement with special
additives.
OPTEK PLUG USES
• Opt-Tek Plug can be applied to vertical, horizontal and
overhead applications:
• static cracks and holes
• water storage tanks
• basements
• building foundations
• retaining walls
• sewers
• below ground car parks
• mines
• anchoring vertical bolts
OPTEK PLUG Benefits
•
•
•
•
•
•
•
•
•
•
•
• mixed just with water or
can be used as a dry powder
• stop water flow
• fast setting with rapid strength development
• permanent durable repair
• can be installed underwater
• high water-stopping power and hydraulic
resistance
• good adhesion to repaired material
• non-toxic
• easy application
OPTEK RF
• OPTEK R-F is a unique brushable penetrative fine cementitious
coating specially designed for waterproofing and protection of old
and new concrete against positive and negative water pressure.
• OPTEK R-F prevents the penetration of water and other liquids into
the concrete by causing reactions that produce non-soluble
cementitious formations within the pores and capillaries of
concrete. These formations grow in the presence of water, blocking
pores, capillaries and minor shrinkage cracks, thus waterproofing
concrete.
• OPTEK R-F contains a Migrating Corrosion Inhibitor which
significantly increases the corrosion protection of steel
reinforcement in concrete.
OPTEK RF USES
•
•
•
•
•
•
•
•
•
•
Concrete water towers and reservoirs
Water treatment and sewage plants
Swimming pools
Roof decks
Underground tunnels
Basements and foundations
Chemical and fertilizer plants
Bridge pylons, beams and decks
Marine structures
Below ground car parks
OPTEK RF BENEFITS
•
•
•
•
•
•
•
•
•
•
•
•
When correctly applied as a coating
OPTEKR-F:
Forms an indivisible body with the base concrete
Significantly increases impermeability of concrete
Resists extreme hydrostatic pressure from either positive or negative
surface of the concrete slab
Can be applied to the positive and negative side of the concrete surface
Can seal hairline cracks up to 0.5 mm
Enhances the properties of concrete against reinforcement corrosion
Significantly reduces chloride penetration
Allows concrete to breath
Does not require a dry surface
Has a life greater than 10 years.
BUILDING RESTORATION
OPTEK R
•
•
•
•
•
•
•
•
•
•
•
•
OPTEK R is a unique penetrative cementitious coating specially designed for the
waterproofing, protection and repair of old and new concrete.
OPTEKR prevents the penetration of water and other liquids into the concrete by
causing the reactions those produce the non-soluble cementitious formations
within the pores and capillaries of concrete.
USES
Concrete water reservoirs
Water treatment and sewage plants
Swimming pools
Roof desks
Underground tunnels
Foundations
Chemical and fertilizer plants
Bridge pylons, beams and decks
SPRAY APPLICATION
OPTEK-R BENEFITS
•
When correctly applied as a coating OPTEKR:
•
•
•
Forms an indivisible body with the base concrete
Significantly increases impermeability of concrete
Resists extreme hydrostatic pressure from either positive or negative surface of
the concrete slab
Can be applied to the positive and negative side of the concrete surface
Can seal hairline cracks up to 0.5 mm
Enhances the properties of the concrete against reinforcement corrosion
Significantly reduces chloride penetration
Allows concrete to breath
Does not require a dry surface
Has a life greater than 10 years.
•
•
•
•
•
•
•
• FOR FURTHER INFORMATION OR TO SEE ALL
THE OPTIMUM PRODUCTS PLEASE VISIT OUR
WEBSITE AT
• www.optiglo.com.au
• Or contact us by email [email protected]
•
[email protected]
• Ph 0432 178 934, 0488 017 385