2 Remove any misfed paper.
3 Close the cover.
3. Paper Misfeed in the Large Capacity Feeder (optional)
1 Open the cover.
2 Remove any misfed paper.
12
Paper Misfeed in the Paper Feed Pedestal (optional)
-Open the cover as shown on the right, and remove any misfed
paper.
3 Close the cover.
259
5.CLEAR PAPER SYMBOL (Cont.)
4. Paper Misfeed on the Bypass Feed Unit
1 Pull out misfed paper on the bypass tray.
5. Paper Misfeed in the Automatic Duplexer
sure that the bypass tray is opened,
1 Make
and then open the automatic duplexer.
- Be careful not to let your fingers be caught between the
equipment and the automatic duplexer.
This could injure you.
- Do not touch the metal portion of a guide board as it could burn
you.
the paper guide as indicated by the
2 Lift
arrow and remove any misfed paper.
the paper guide and return the
3 Lower
automatic duplexer to the original
position.
12
260
- Be sure to close both sides of the Automatic Duplexer firmly.
12.WHEN THE GRAPHIC SYMBOLS BLINK ON THE TOUCH PANEL
6. Paper Misfeed in the Jam Releasing Unit
sure that the bypass tray and the
1 Make
automatic duplexer are open, then open
the jam releasing unit cover.
the green knob as indicated by the
2 Rotate
arrow toward the inside and remove any
misfed paper.
the jam releasing unit cover, the
3 Return
automatic duplexer and the bypass tray to
the original positions.
- Be sure to close both sides of the automatic duplexer firmly.
7. Paper Misfeed in the Fuser Unit
sure that the bypass tray, the
1 Make
automatic duplexer and the jam releasing
unit are open, and push down the 2 fuser
pressure release levers until they come to
a stop.
12
Be sure to perform step 1 without fail.
DO NOT touch the fuser unit and the metal area around it. Since
they are very hot, you could be burned or the shock could cause an
injury to your hand in the equipment.
261
5.CLEAR PAPER SYMBOL (Cont.)
2 Open the fuser unit cover.
the knob (A), open the transport
3 Holding
guide.
(A)
any misfed paper inside the fuser
4 Remove
unit.
the transport guide and the fuser
5 Close
unit cover. Push up the fuser pressure
release lever to return the jam releasing
unit cover, the automatic duplexer and the
bypass tray to the original positions.
12
the lever toward you to loose the
6 Pull
misfed paper. Hook a finger under the
(1)
loosen part of it, and then pull it out.
(2)
262
12.WHEN THE GRAPHIC SYMBOLS BLINK ON THE TOUCH PANEL
pull it out with both hands to
7 Furthermore,
remove it.
8. Paper Misfeed in the Relay Unit (optional)
the cover handle of the relay unit,
1 Holding
open the cover.
any misfed paper that is inside
2 Remove
the relay unit.
12
z Remove the misfed paper from the fuser unit side if it is easier.
3 Close the relay unit cover.
263