Model 600/650 Instructions

50 ENGINEERS ROAD
HAUPPAUGE, N.Y. 11787
516.562.6161
600 / 650
Terminals
Terminals
1-2
3-4
600/650
600/650
INSTRUCTIONS
- use 115 vat input from 24 hr. outlet.
LVT - use transformer
MODEL 871 7vac
THE TUI'ALCURRENT AVAILABLE ON.THE PANEL IS 3
AMPS.
Switch
24 b. panic: open circuit
the bell to ring.
NOTE - Depending upon the position
switch.
will
- n closure
cause
of the SILENT AUDIBLE
Terminals
5-6
wire thermostats
in parrallel
- a
Open Fire Circuit:
closure on this circuit
will cause spare contacts 9 & 10,
(If optional
661 pulsating
relay & tube
11 & 12 to close.
is used, burglary
bell will pulsate on fire;
6 (+)
rerminals
7-8
Open circuit
contact that closes when burglary
or panic
Can be used for dialer,
siren,
or
circuit
is tripped.
any electrical
circuit
up to 3 amps.
rerminals
g-10
Open circuit
contact that
Can be used for
tripped.
circuit
up to 3 amps.
Terminals
11-12
Same as 9 86 10. Can be used to power fire horn model
519 by connecting
horn to terminals
11 & 14 and by placing
when not using pulsating
a jumper across 12 & 13. Note:
fire option 661. this is required
to get audible signal
from fire circuit.
Terminals
13-14
Smoke Detector Output: Continuous 6-9 volt output.
Momentarily pushing reset switch will interrupt
power and
reset smoke detectors.
Terminals
15-16
Spring loaded key or open circuit
closure used to switch from white
Terminals
15-21
White Light Circuit:
indicates
condition
of protective
Light out indicates
loop is open, light
on
circuit.
indicates
loop is closed.
Terminals
15-24
Red light
indicates
status of system.
Red light
circuit:
NOTE: Since terminal
15 is
on fndicates
system is armed,
and red light
circuit,
the same for the key, white light
only 4 wires a& required
for a remote station.
Remote
stations
may ba.,made tamper proof by using a 5 wire cable.
Place a normally
closed tamper button behind remote statior
and wire one side of button to terminal
4 and the other
side to terminal
15.
I'erminals
17-18
Closed Circuit
terminals
Terminals
19-20
Loop:
Closed Supervisory
THIS CIRCUIT
REMEMBER..
wire
closes
dialer.
entire
when fire circuit
is
siren.
or any electrical
push button (momentary'
light
to red light.)
protective
loop to these
_ ._
Loop:
. -Wfi
DO NOI' USE COAXFACTSOR FOIL ON
DO WHAT
THEY
DDNT”
ISSUE &
DATE
2/2779
Terminals
22-23
Option:
24 Hour Holdup Open Circuit:
requires # 882
optional
police connect relay.
A momentary closure on
this circuit
will cause the police connect to reverse
Note: bell will not sound. To reset:
and lock-in,
momentarily push reset (lower right).
To eliminate
lockin, jumper 55 may be cut.
NOTE: With 55 cut a latching
hold-up button must be used.
Terminals
25-26
Bell Output:
6-g volts on burglary
or panic.
There is
no bell output on fire unless option 661 is used. This
option will cause the bell to pulsate on fire.
The burglary,
panic bell may be silenced by the SILENT/AUDIBLE switch
The panel will ring 2 bells (we
on the front of panel.
recommend no more than two).
Terminals
27-28
Option:
Police connect - active only when model $882
police connect is used. Connect telephone lines to terminal
The polarity
will reverse
27 (positive)
and 28 (negative).
when burglary,
panic,' fire or 24 hr. holdup is activated.
model #663 time-delay
tube may be used to delay
Option:
the reversing action for 30 sec. (on burglary only,)
3-Be sure to cut
jumper Jl when using this option.
x
Loose Wires:
Two White Wires:
open dry contact
connect option (882) activates).
that
closes
when police
Red & Black Wires:
Red Wire - 600- connect to pos.it$ve of dry cell battery
650- connect to positive
of rechargeable battery
(use snap-on clip)
Black Wire - LOO- connect to negative of dry cell battery
650- connect to negative of rechargeable
battery (use snap-on clip)
Panel Switches:
Silent Audible Switch: This switch will silence bell output on burglary and panic (will not affect fire output)
Reset Switch: This switch will reset panic, fire,smoke
detector,
and police connect.
NOTE: IF POLICE CONNECTIS TRIPPED, IT MUST BE RESET AT
PANEL, CUTTING JUMPERJ5 WILL ALLOWFOR RESET AT REMOTE
STATIONS.
I.
‘/2AMP
SLOW
*ON 64X/650
BLOW
L.V.T.
0
’
BURGLARY PANIC
8 m @AUDIBLE
SILENT
BELL
RESET
PANIC flRE
sms
SMOKE. DE’rrctXgR
PANIC SWITCH
N. 0. PUSH BUTTON ’ +
l
-SMOKE
DETECTOR
ON L.V.T. HOOK*871
TRANSFORMER To l&2
PROTECTIVE
BLACK
1 LIGHT
I N.O.
L LOOP
MATS
\
A
\I
WITH 650
ONLY
,,,->
I-
..