Instruction Manual
Effortless Heavy Duty 2-Hole punch
09546:100 sheets
09556:200 sheets
Important Instructions for Effortless
Lever-Tech Heavy Duty 2-Hole Punch
Please read before using this product
1. Designed for use on Standard Paper Only. Do not use to punch
special papers such as board, vinyl covered or cloth covered paper, nor
materials other than paper. Misuse will result in damage to your POWER
PUNCH.
2. Effortless Heavy Duty Punch Cutters are designed to cut EASILY through
up to 100/200 sheets copy paper. Evenly applied pressure to the handle
should result in an EASY cutting action.
Please assemble chip drawer and ÀQJHU protect cover before
use.
chip
drawer
finger
protection
3. Should the punching action become forced or incomplete, DO
NOT APPLY EXCESSIVE FORCE as this will damage Effortless
Heavy Duty PUNCH and / or the CUTTERS
6SHFLÀFDWLRQ
Model name
Capacity
09546
Up to 100 sheets
09556
100
Cutter diameter
口6 mm；口7 mm
Distance between two holes
口80 mm；口70 mm
Format indication
A4-A6
Up to 200 sheets
MAX.
457mm
200
MAX.
Lever-Tech Heavy Duty 2-Hole Punch
A. Assembling punch
Fig. 1: Before operates the puncher,please
put the chip drawer and finger
protecter properly
Fig 1
chip
drawer
finger
protection
B. Operation for paper guide (4-holes for 80mm distance only)
Fig. 2 .3. 4: To set up the free size easily and wide open paper guide
completely for easy punching 4-hole by sliding paper at both
ends for 80mm spec. punch only.
Fig 2
80mm
Fig 3
80mm
80mm
80mm
Fig 4
Fig. 5, 6 : Automatically postioning paper guide for easy precise punching for
A4 by “ straight” and End” size
A4
Fig 5
A4-A6
Fig 6
D. Empty chip drawer
Fig 7: To clean and empty chip
drawer at the maximum mark
line from time to time.
Fig 7
*FULL
E. Replace plastic disc
Fig. 8 : For 100 sheets puncher to
slide the plastic disc parallel
out and replace new one.
Fig 8
Fig 9
*CHANGE
Fig. 9 : For 200 sheets puncher.
Please use flat tool to lift up
the disc and replace new
one.
F. Replace new hollow cutter
Fig. 10:
1 Please raised up the handle.
2 Press the button to release the
cutter carrier at both sides.
3 Replace the new cutter.
4 Push back to the mechanism
firmly.
Fig 10
1
3
2
4
G. Clear stuck paper chips
Fig. 11 : Be sure to clean the
paper chip after use every
time to avoid the stuck
paper to cause extra
power and break the
cutter.
Fig 11
2
1
I. Tool box accessories are
option and purchase
separately
Fig. 12:
The puncher is equiped with
spare plastic discs for free.
The cutters are optional and can
be purchased separately.
Tool box content option :
ͫ 09556 : 2 punch pins + 4 discs
ͫ 09546 : 2 punch pins + 2 discs
www.kw-trio.com
99999-160217-04
Fig 12
09556
09546