Product Specification
Nitoflor FC120HB
Heavy duty, high build, floor coating, chlorinated rubber, UV stable, for trafficable floors
and car parks
*1.00
Floor coating
1.10
Substrate Preparation
1.11
Where so designated on the drawings, internal concrete floor surfaces shall be coated with a
one component, chlorinated rubber floor coating providing a surface treatment to protect against
wear and limited chemical attack.
1.12
General
All surfaces shall be prepared, and the coating material applied strictly in accordance with the
current manufacturer technical data sheet.
All work shall be carried out by an experienced contractor, who is well trained in application of
the specific, documented, coating system.
All materials used in conjunction with the coating system, shall be approved by the coating
manufacturer.
1.13
Surface Preparation
All surfaces to which the new coating material is to be applied shall be fine textured, clean,
sound, and free from loose material and contamination such as plaster, oil, paint and grease.
Concrete substrate must not have a relative humidity of greater than 80% at the time of coating
application.
Excess laitance should be removed by light scabbling or captive shot blasting followed by
vacuuming to remove all dust debris.
All large substrate cracks, holes, surface imperfections which may cause excessive wearing on
high spots and change the perceived colour of the coating are to be removed, filled, and dry,
prior to coating application.
For applications where water vapour seepage or moisture are of concern, pre-treatment and
priming with a manufacturer approved moisture barrier must be used.
Parchem Construction Supplies
Document Date: 09/2009
Page 1 of 2
Parchem offers direct assistance with specifications for individual projects; we can visit the site, design office, or
arrange a meeting at our branch office. It is recommended that Parchem be consulted early in the design process.
For Technical Data Sheets (TDS), Specifications and Method Statements, please visit our website at
www.parchem.com.au. * To insert the Specification, Copy and Paste.
Product Specification
1.20
Floor sealer coating
1.21
The floor coating is to be a one component, heavy duty, UV and wear resistant, low gloss
surface finish to concrete surfaces.
1.22
The material is to be applied in two coats to achieve an approximate total dry film thickness of
160 microns.
The coating material shall exhibit the following approximate properties:
Dry film thickness:
Drying time:
Solids content w/w:
160 microns approx.
24 hours minimum
40% Clear;
60% Coloured
1.23
Nitoflor FC120 HB from Parchem Construction Supplies meets the product criteria and is
approved.
Parchem Construction Supplies
Document Date: 09/2009
Page 2 of 2
Parchem offers direct assistance with specifications for individual projects; we can visit the site, design office, or
arrange a meeting at our branch office. It is recommended that Parchem be consulted early in the design process.
For Technical Data Sheets (TDS), Specifications and Method Statements, please visit our website at
www.parchem.com.au. * To insert the Specification, Copy and Paste.