Nellcor™
Reusable Pediatric SpO2 Sensor Clip (D-YSPD)
Application Guide
D-YSPD
1
A
(a)
(b)
2
3
A
B
B
(a)
(b)
(c)
Figure A shows (a) the metal loops and (b)
the plastic clip. Figure B shows the sleeve
with (a) placement target (soccer ball
symbol), (b) placement indicator (straight
line), and (c) the dimpled finger grip.
4
Remove the elastic sleeves (one at a time) from
the plastic clip by gently lifting the wide dimpled
end of each sleeve off the wide end of the clip.
Then grasp the sides of the narrow end of the
sleeve and gently slide the sleeve off the clip.
5
6
(a)
Replace each elastic sleeve. Then gently stretch
the pocket of the wide end of the sleeve
over the wide end of the plastic clip. The
soccer ball on the sleeve is a visual indicator
of the emitter or detector underneath.
A Insert the pads through the center
opening of the wide end of the plastic clip.
B Engage the “button” of the sensor pad
with the extended metal loop by grasping
the pad and gently pushing it into the loop.
(b)
(c)
(a)
(d)
View of the Pediatric SpO2 Sensor Clip on a
finger that (a) is too small, (b) is too large,
(c) fits correctly and (d) also fits correctly.
Position the clip on the finger such that (a)
the straight line on the sleeve (the placement
indicator) is at the tip of the finger.
Do not cover the entire finger with
the clip. Improper placement may
lead to inaccurate measurements.
If you have any questions, contact your Nellcor product representative at 877-664-8926.
CLEANING
Caution: To avoid damage to the elastic sleeves,
do not turn them inside out during cleaning.
Caution: Do not sterilize by irradiation, steam, or
ethylene oxide.
Do not immerse the connector end of the
cable as this may damage the sensor.
3. Do not use the Pediatric SpO2 Sensor Clip and D-YS model
sensor during MRI scanning. Conducted current could cause
burns. Also, the sensor may affect the MRI image, and the
After each cleaning and prior to each use, inspect the clip and
MRI unit may affect the accuracy of oximetry measurements.
sleeves for fraying, cracking, tearing, breakage, or other damage.
WARNINGS
It is not necessary to remove the D-YS model sensor
from the clip before cleaning, or to remove the
sleeves from the clip assembly prior to cleaning.
1. D
o not use the Pediatric SpO2 Sensor Clip for unattended or
continuous monitoring as clip pressure could compromise
patient skin integrity and/or possibly cause neural damage.
Clean the assembled clip, sensor, and sleeves by wiping the
surfaces with a gauze pad that has been soaked in 70%
isopropyl alcohol or a solution of 1:10 bleach (5.25% sodium
hypochlorite) and water. Then wipe the surfaces with a gauze
pad that has been soaked in sterile or distilled water.
2. D
o not expose the sensor and pediatric clip to bright ambient
light during use; this may cause inaccurate measurements. In
such cases, cover the sensor site with an opaque material.
Read the sensor’s “Directions for Use” insert for
complete instructions for use, including all warnings,
cautions and specifications, prior to use of this product.
COVIDIEN, COVIDIEN with logo, Covidien logo and positive results for life are U.S. and internationally registered
trademarks of Covidien AG. Other brands are trademarks of a Covidien company. ©2014 Covidien. 14-PM-0337
6135 Gunbarrel Avenue, Boulder, CO 80301 800-635-5267
www.covidien.com