2014 International Conference on Engineering Tribology Technology
-----------------------------------------------------------------------------------------------------------------------
The International Conference on Engineering Tribology Technology of Taiwan
Da-Ming Wong1, Xiao-Chung Chen2 (12 points, Times New Roman, Center)
Department of Power Mechanical Engineering, Nation Formosa University
2
Department of Vehicle Engineering, Nation Formosa University (12 points, Times New Roman, Center)
1
E-mail: 1 [email protected] 2 [email protected] (11 points, Times New Roman, Center)
Abstract (11 points, Times New Roman, Boldface, Center)
3.2 Equations
Equations should be labeled with a number towards
the right margin, in case there is more than one
equation.
The 1th International Conference on Engineering
Tribology Technology of Taiwan will be held in Sun
Moon Lake, Nantou by Taiwan Society of Tribology
Technology, from Nov 21 to 23, 2014.
PI  
(Abstract content 10 points, Times New Roman)
Keywords：Janfusun, Guidelines, TSTT
rn
ri
(1)
pI dA
4. Result
(2～4 Words,10 points, Times New Roman)
References are identified by a number in brackets
and should follow the format as seen in the examples
below for journal paper [1], book [2], conference paper
[3], thesis [4], technical report [5], patent [6], and
website [7].
1. Introduction
All papers are limited to 1 full page. Authors should
adhere to these guidelines and if the paper was not in
the correct format, we will not recommend publishing in
the conference.
5. Conclusions
If you have problems or questions, please feel free
to contact with seminar member.
2. Format
2.1 Paper format
6. Acknowledgment
Thanks to all those people.
2.1.1 Margin setting
The paper size is A4 (21 cm wide by 29.7 cm tall)
with the margins: upper 3 cm, lower 3 cm, left 2 cm,
right 2 cm. These settings must not be altered under any
circumstances!
7. References
1. D.M. Wang, S.C. Chen, “CNC Lathe Cutting
System”, Journal of Technology, Vol.1, No.1,
51-56, 2012.
2. X.M. Wang, Tribological and Manufacturing
Science - Theory and Practice, 5-30, San Min Book,
Taipei, Taiwan, 2010
2.1.2 Font setting
The only fonts that should be used are: Times New
Roman and Symbol. The title is in capitals, 14 point,
boldface, the authors and their affiliations 12 points. The
subtitles in the text are 11 point, boldface. The rests of
the text are 10 point.
8. Chart arrangement
2.1.3 Line space setting
Line space is fixed to 12 point. Figures, tables and
equations are edited by a single space.
2.2 Keywords
A list of up to 2-4 keywords should be included
right after the abstract.
Fig.1 Annual contribution of conference on Tribology
Technology of Taiwan
3. Figures, tables, and equations
3.1 Figures and tables
Figure (and table) captions should be written in 10
points, Times New Roman. Captions can either be
centered or fully justified, depending on the width of the
figure.
Date
Place
1
Table 1 Dates and place for the conference
2014.11.21-23
Sun Moon Lake, Nantou