Draper 31096 Interchangeable Hole Punch and Eyelet Pliers
To use as a Hole Punch:
Select the brass anvil (located inside the handle) and the required
diameter of punch and screw them into the jaws of the pliers. Any
punches or dies previously in the jaws can be stored in the handle.
Place the item to be punched between the jaws and squeeze the
pliers closed. The punches are hollow, so any waste material can be
easily pushed out.
To use as Eyelet Pliers:
Firstly, punch a 4mm hole in the material as described above.
Select and fit the eyelet formers. (Shown in the pliers’ jaws in the
illustration.) Push an eyelet through the hole in the material and
position the ready-made end of the eyelet into the former with the
hole rather than the one with the raised cone. (The raised cone
shapes the other end of the eyelet.) Squeeze the pliers closed until
the eyelet is formed and holds the material.
© Rapid Electronics. Revision A: December 19th 2012