Date
Reference
2013-09-12
2012/343
Industry and Installations Division
Per Fällström
Direktnr: +46 (0)33 177749
E-post: [email protected]
Your reference
Jonas Balderud
Outokumpu Stainless AB
Box 74
774 22 Avesta
Decision concerning extended accreditation
(3 appendices)
This decision replaces earlier issued decision dated 2011-06-10 and 2012-04-26,
reference number 10-2560-51.1963 and 12-658-51.1936.
Outokumpu Stainless AB has applied to the Swedish Board for Accreditation and
Conformity Assessment, Swedac, for extended accreditation due to new editions
of the methods.
Based on the received application, the assessment report dated May 10-11 2012,
and your reports on actions taken to correct non-conformities SWEDAC hereby
decides, in accordance with article 5 point 1 in the Regulation (EC) No 765/2008 of
the European Parliament and of the Council setting out the requirements for
accreditation and market surveillance, and the Act (SFS 2011:791) concerning
Accreditation and Conformity Assessment, to approve extended accreditation for
Outokumpu Stainless AB, subject to the accreditation terms as set out in Appendix
1. Any change of the terms shall be notified to, and be approved by, Swedac. The
scope of the accreditation is set out in Appendix 2, and can be changed only
through a new decision by Swedac.
The attached accreditation certificate summarizes information concerning the
accreditation that may be important to the laboratory’s customers. The certificate
is presented in a form that complies with the guidelines set out in ISO/IEC 17011.
Outokumpu Stainless AB has previously assigned accreditation number 1098.
The accreditation applies until further notice. Regular surveillance visits will be
performed as described in the applicable regulations on accreditation.
1 (2)
Swedac
Tel: +46 771 99 09 00, www.swedac.se
E-mail: [email protected]
Organisation No: 202100-3815
Head Office
Postal Address: Box 878, SE-501 15 Borås
Visiting Address: Österlånggatan 5
Fax: +46 33 10 13 92
Stockholm Office
Postal Address: Box 733, SE-101 35 Stockholm
Visiting Address: Klarabergsviadukten 70 D7
Fax: +46 8 791 89 29
Date
Reference
2013-09-12
2012/343
Accredited laboratories pay an annual fee in accordance with Swedac´s
regulations. Your laboratory is in fee group XIV. Travelling expenses and cost of
technical assessment will be invoiced separately.
This decision has been taken by Division Manager Pernilla Carlsson in consultation
with the Technical Officer Per Fällström.
Pernilla Carlsson
Division Manager
Appendices
1. Terms of accreditation
2. Scope of accreditation
3. ISO-ILAC-IAF communiqué
Accreditation certificate
Please notice that this is a translation, in case of any discrepancies between the
English version and the original Swedish version the latter will prevail.
2 (2)
Appendix 1
Date
Reference
2013-09-12
2012/343
Terms of accreditation
1
General terms
The requirements for accreditation are specified in the following documents:
STAFS 2010:10
The Swedish Board for Accreditation and Conformity Assessment’s
(Swedac) Regulations and General Guidelines (STAFS 2010:10) on
Accreditation
STAFS 2011:33
The Swedish Board for Accreditation and Conformity Assessment’s
(Swedac) Regulations and General Guidelines for the Accreditation of
Laboratories
STAFS 2011:33 includes all the requirements of SS-EN ISO/IEC 17025.
2
Special terms
2.1
Company/Organisation
693 81 Degerfors
Organisation registration number:
2.2
556001-8748
Location
The accredited activities are conducted at Outokumpu Stainless AB, DEGERFORS
1 (1)
ACCREDITATION CERTIFICATE
1098
ISO/IEC 17025
Outokumpu Stainless AB
Registration number 556001-8748
is accredited as a testing laboratory for the scope specified in appendix 2. The applicable terms of the
accreditation are specified in appendix 1.
This laboratory is accredited in accordance with the International Standard ISO/IEC 17025:2005. This
accreditation demonstrates technical competence for a defined scope and the operation of a laboratory quality
management system. The accredited laboratory is responsible for the results of performed testing and
submitted judgements as well as, where applicable, for the selection and application of work methods within
the scope of the granted accreditation.
The accreditation is valid until further notice. The Swedish Board for Accreditation and Conformity Assessment
(Swedac) regularly carries out surveillance, and a full reassessment every fourth year, in order to verify that the
applicable terms of accreditation, see appendix 1, are continually fulfilled.
This accreditation certificate was issued 2013-09-12 by
Pernilla Carlsson,
Manager of the Industry and Installations Division
Accreditation was granted in accordance with article 5 (1) or Regulation (EC) No 765/2008 regarding accreditation and market surveillance
etc. and the Act (SFS 2011:791) concerning Accreditation and Conformity Assessment. Swedac is the national accreditation body
responsible for the assessment of the competence of certification bodies, inspection bodies, laboratories and environmental verifier
applying for accreditation. This accreditation has been issued under the EA MLA and is therefore recognised as equivalent to other
accreditations issued under the EA MLA within the same accreditation scope.
1 (1)