Rubber Hoses | Water & Air hoses
Seawater dump hose - hard wall
Oil rig water suction & discharge hose 10 bar
Application
◾◾ dumping of waste water and other materials from
the rig deck to the sea surface
◾◾ usually supplied in sections and supplied with
high strength couplings to carry the weight of the
full hose string
Cover
◾◾ black CR blend
◾◾ oil, abrasion and weather resistant
Assembly
swaging ferrules (up to 6”) or built in fittings
Temperature range
-30 °C to +80 °C
Burst pressure
◾◾ minimum 40 bar
◾◾ safety factor 4:1
Built in type fitting
Fixed or swivel type flange, high strength joint
with good stress distribution along the hose.
Available in carbon steel, stainless steel.
Tube
◾◾ black CR blend
◾◾ oil, abrasion and weather resistant
Internally swaged end
Swivel or fixed type flange in carbon steel,
stainless steel. Reinforcement
opposing layers of high tenacity polyester tire cord
with embedded steel wire helix
Table 1: Seawater dump hose - hard wall
I.D.
inch
mm
Wall thickness
Working
pressure
Bending
radius
Weight
Roll length
mm
bar
mm
kg/m
m
152
6“
11,0
10
850
11,90
61
203
8“
12,0
10
1125
16,20
40
254
10“
16,0
10
1400
22,90
12
305
12“
19,0
10
1675
34,40
12
356
14“
20,5
10
1960
49,50
12
Disclaimer: The content of this document has been composed with the utmost care. However, it is possible that certain information changes over time, becomes inaccurate or incomplete. ERIKS does not guarantee that the information provided on this document is up to date, accurate and complete; the information provided is not intended to be advice.
ERIKS shall never be liable for damage resulting from the use of the information provided.
For more information, quotations or orders: Phone +31 72 514 18 22 or E-mail [email protected]
page 1/1
ERIKS bv • P.O. Box 280 • 1800 BK Alkmaar • The Netherlands • T +31 72 514 15 14 • [email protected] • www.eriks.nl
D06100310010-en_18.08.2016