AVL USER GUIDE (GSM)
Automatic Vehicle Locator Manual
Korea위치정보통신
www.sos007.co.kr
TEL: +82-2-333-2505
FAX: +82-2-333-5885
E-mail: [email protected]
Mobile:+82-10-7396-6669
2008. 01
1
1. Product Introduction
1-1) Product Introduction
 Vehicle Control Unit AVL (GSM/GPRS)
Components
Specifications
CPU / Solution
ARM 7TDMI, MediaTek Solution
MEMORY
ROM( Flash memory) 16Mbyte, SDRAM 4Mbyte
SMART GPS
SiRFstarIII GSC3f/LPx (Active antenna available)
- Low power consumption, High performance
- Position Accuracy : < 2.5m, <2.0m(SBAS)
-TTFF : < 1 sec(Hot Start), < 35 sec(Warm/Cold Start)
GSM Quad-band(850/900/1800/1900 MHz),
GSM Modem
GPRS (Class 12, included TCP/IP)
Internal battery Available ( Optiona1)
10 Pin I/O
Interface
- Included Main Power, 1 Serial Port, 1 Emergency Button,1 engine restart prevention.
1 Audio Port ( Mic/Speaker, Optional)
Power Supply
Others
12~30V DC
Material : Aluminum
Reverse voltage prevention diode, over-voltage prevention component.
2
Remark
1. Product Introduction
1-2) Product Detailed specification – LBS Functions
Index
LBS
Function
Optional
Function
Function
1. Enter a restricted area alarm function
- If the vehicle enter a restricted area, report to center
2. Immediate location tracking function
- If it received the requiring locations at once, report location information to center
3. Report last stop( engine stop) location to center
- If the vehicle’s engine stop, report location and engine stop information to center
4. Updating server ( control center ) information
- The device is updated server information( address, etc.) by SMS command
5. Report current setting information to center
- The device report device setting values( server address, cycle time, etc) to center
6. Report self-test results to center
- The device report result of device’s self-test to center
7. Emergency button
- If it occurred emergency situation, report to center immediately
8. Detect vehicle engine start
- If vehicle start engine, report to center
9. Prohibit vehicle engine start
- If vehicle set prohibit restart engine by control center, Driver can not start engine
10. Block-box function
- Store tracking location information in included memory
11. Detect cut off GPS antenna function
-If someone remove a GPS antenna, report to center .
1. Include Li-ion battery( Optional 400mAh battery)
-If someone remove a vehicle battery, report to center using included battery
2. Intercept audio in car function.
- it can Intercept audio by center. (Optional microphone )
3
Remark
2. Product Function
1-1) Product Function switch-a
Power Signal
LED
Linked to the GSM
Antenna
Linked to
Mic/Spearker
GPS Signal
LED
Linked to the GPS
Antenna
Linked to the
Main Connector
GSM Signal
LED
Plug SIMCARD
Front side
Back Side
4
2. Product Function
2-2) Product Function switch-b
 Main Connector
 LED Indicator
10
9
8
7
6
5
4
3
2
1
Power
 Main Connector Pin Define
Pin Num
Define
I/O Type
Mark
B+
Input
Vehicle battery + ( 10 ~ 30V)
2
IGN
Input
Vehicle ignition signal sensing port
Device power on when this signal is high
3
Emergency
Switch
Input
Emergency Switch Input
4
Uart Tx
Output
Serial interface TX (RS232) - Optional
5
Ground
Ground
Vehicle Battery Ground (common
ground) - Optional
6
Ground
Ground
Vehicle Battery Ground
7
Aux Output-01
Output
Auxiliary Output Port - Optional
8
ST_Control
Output
Immobilizer, Re-start prevention function
9
Uart Rx
10
Out_power
output
GPS
 LED Function Define
1
Input
GSM
LED Color
Define
1. LED Off: Power Off
2. LED On: Power On
Power LED (RED)
3. LED Blink at intervals of 0.5Sec
: Main battery (B+) power line is disconnected
Modem LED
(Green)
GPS LED
(Yellow)
Serial interface Rx (RS232) - Optional
12V / 5V (factory setup) (Max 1A@5V) Optional
5
Green LED indicates the status of GSM/GPRS modem
1. LED On: Normal operation
2. LED Blink at intervals of 1 Sec: Network search
3. LED Blink at intervals of 0.5 Sec
: Limited or No service state
Yellow LED indicates the status of GPS
1. LED On: Satellites found and location fixed,
2. LED Blink at intervals of 1 Sec
: Invalid GPS data, position not fixed
3. LED Blink at intervals of 0.5 Sec: GPS wire disconnection
4. LED Off: GPS Module Power Off
3. Product Installation
3-1) Product Installation – Main Cable
a. Main Cable Connection
Pin Num
1
Define
B+
10
9
8
7
6
5
4
3
2
1
Color
I/O Type
Mark
Red
Input
Vehicle battery + ( 10 ~ 30V)
Yellow
Input
Vehicle ignition signal sensing port
Device power on when this signal is high
Ex) . Connect to Battery of Vehicle or
. Connect to ignition signal of Vehicle
Emergency Switch Input
2
IGN
3
Emergency Switch
Blue
Input
5
Ground
Block
Ground
Vehicle Battery Ground (common ground) - Optional
6
Ground
White
Ground
Vehicle Battery Ground
ST_Control
Green
Output
Immobilizer, Re-start prevention function
4
7
8
9
10
6
3. Product Installation
3-1) Product Installation – Main Cable
b. Main Cable Connect to Vehicle
Black
Emergency Button
Blue
GSM Antenna
AVL
Connect to Ignition Line
Yellow
(ACC / Start)
Connect to Relay
Green
White
Test or Always System
GPS Antenna
power On
RED
RED
It will be power ON the device when the Yellow line be
supplied power(12V)
7
Car
Battery
3. Product Installation
3-2) Product Installation– Antenna
GSM Antenna
GPS Antenna
8
3. Product Installation
3-3) Product Installation– SIMCARD
Push-Push Type SIM Card Socket
9
3. Product Installation
3-4) Product Installation– Internal battery On
On
Off
• Back Side Battery power SW
- This switch must be on for the device operation.
10
4. Product Diagram
1) Product Block Diagram
GPS D/L
Slide SW
GSM Quad
Band
Antenna
GSM RF
GPS
Active
Antenna
GPS
Debug
Port
GSM
Debug
Port
From
Vehicle
Ignition
Signal
GPS Module
(SRF III)
From
Vehicle
Battery
12~24V
Power Block
(Input to 5V)
Uart/Reset
/Antenna
Detector
Detector
Low Voltage
Audio Port
Emergency
Button
Cut Restart
to Vehicle
Photo
Coupler
GSM
Power Block
GSM Main Processor
Multi Port
Power Supplier
Photo
Coupler
Battery
Memory
(Flash/Sdram)
Slide SW
11
5. Product Function
1) Product Function – Board Picture
Debug Port
GSM Block
Power Block
GPS D/L SW
: Normal Operation
: GPS F/W Download
12
Battery
Connector
6. Product H/W Specification
1) Product H/W Detailed specification
 General Specification
 GPS Specification
Index
Descriptions
Form Factor
Blok-Box Type, AVL (Automatic Vehicle Location) System
Band
Quad Band GSM 850,900,1800,1900, GPS
GPS
SiRF Star III
Dimension
Antenna
Weight
128 / 32 ( FLASH / SDRAM)
SirfstarIII GSC3f/LPx
50MHz ARM7TDMI processor plus 1Mbit SRAM / 4Mbit flash
Normal
SBAS
< 2.5m
< 2.0m
TTFF
- Hot Start :
<
1 sec
- Ward/Cold Start : < 35 sec
Sensitivity
Data
TCP/IP, GPRS Class-12, Circuit-switched Data
SMS
MT/MO
3 LED Indicator
Acquisition
Tracking
-142 dBm
-159 dBm
States indicator of GPS, GSM, Power
490 mAh -Optional
 Power Consumption
10Pin Main Connector, 3-Pol Audio Port
Provide external Emergency button ( Cable Type)
LBS Feature
Over the Air Terminal (AVL) Control : - SMS, TCP/IP
Auto Detect
Auto detect functions : Low Battery, Cut Battery, Cut GPS Ant.
3 LED Indicator
Descriptions
Time To First Fix
About g((Include standard battery)
O.S Memory
Emergency button
Position Accuracy
Dual Internal (Active GPS / Bar type GSM )
3 Pol Interface port
Interface
Solution
12.6 x 90.0 x 21.2 mm ( W x L x H )
Speaker/Mic
Battery
Index
Index
Idle mode
Consumptions for mode
States indicator of GPS, GSM, Power
 Environment Specification
Index
Storage Temperature
Operation Temperature
Operating Humidity
Descriptions
Descriptions
< 3mA
GPS Off, GSM standby mode
Normal mode
100 ~ 250mA
GPS + GSM Rx/Tx Operation
Max Operation 350mA
- Standby time
Internal Battery
( 490mAh Battery)
-40 C to +85 C
• -30 C to +65 C
up to 80%
13
: 160 hours
GPS Off, GSM standby mode
- Operation Time : 2.5 ~ 4.5 Hours
Continual tracking mode