MOBL-300x150
Back Light
HIGH OUTPUT
Features

Microprocessor regulation of LED’s

Driver built in – No External wiring to a driver

PNP and NPN Strobe input

Continuous operation

Standard industrial 45mm Aluminum Extrusion Frame
provides ease of mounting.
Electrical Input
Voltage - 24 VDC +/- 5%
Power On Delay
Light has a power up sequence for 5 seconds – see below
Power Requirement
6 amps at 24VDC
Continuous Mode
Light will be in continuous mode by leaving signal on strobe input
ON/OFF - Strobe
PNP ► +4VDC or greater to activate.
ON/OFF- Strobe Mode
NPN ► GND (<0.7VDC) to activate
The Light will operate in either continuous or on/off strobe mode. In strobe mode, the output
pulse width will track the pulse width of the strobe pulse.
Pin and Cable Color Assignment
Connector on Light
1 = 24VDC
2 = NPN STROBE
3 = GND
4 = PNP STROBE
5 = 0-10VDC Analog
Standard M12 mating cable color assignment:
BROWN
WHITE
BLUE
BLACK
GREEN (GRAY)
If Analog 0-10 VDC is not used to control light intensity;
+VDC (24VDC) must be connected to Analog Input - Jumper pin 5 to pin 1 or Green wire to Brown wire.
!
Important
Please note that the power requirements are 6 amps at 24VDC. Failure to supply light with 6 amps
(peak) will result in non-repeatable lighting. Contact Smart Vision Lights for more information.
Smart Vision Lights • 2359 Holton Rd. • Muskegon, MI 49445 •Phone 231.722.1199
www.smartvisionlights.com