DMC-300SC
100BASE-T to 100BASE-FX multi-mode
Media Converter
Rev. C1
Reliability Test Report
APPROVED
CHECKED
DEPARTMENT
1
PREPARED
Table of Contents:
PASS or Fail
1. Storage Temperature Test
■
□
2. Low Temperature Test
■
□
3. High Temperature Test
■
□
4. Temperature & Humidity Test
■
□
5. Four Corner Test
■
□
Switch:
DMC-300M
Rev. C1
2
1 Storage Temperature Test
1.1 Sample Size : 2 pcs
1.2 Test Condition :
The DUTs should be placed in the chamber to complete 6 cycles and subjected to the
following conditions :
* Non-Operating
Temp.
70℃
25℃
-20℃
0 1 2
5 6
7
8
11 12
Hrs
1.3 Results :
1. Visual inspection was normal.
2. Data transmit & receive function was normal during the test.
3
2 Low Temperature Test
2.1 Sample Size : 2 pcs
2.2 Test Condition :
The DUTs should be placed in the chamber to complete 1 cycle and subjected to the
following
conditions:
* Operating
* Ramp temperature down to 0 ℃ in 1 hour.
* Hold Low temperature at 0 ℃ for 72 hours.
* Ramp temperature up to 25 ℃in 1 hour.
Temp.
℃.
25℃
0℃
0 1
73 74
Hrs
2.3 Results :
1. Visual inspection was normal.
2. Data transmit & receive function was normal during the test.
3. 0℃power on and TX/RX function was normal.
4
3 High Temperature Test
3.1 Sample Size : 2 pcs
3.2 Test Condition :
The DUTs should be placed in the chamber to complete 1 cycle and subjected to the following
conditions:
* Operating
* Ramp temperature up to 55 ℃ in 1 hour.
* Hold High temperature at 55 ℃ for 72 hours.
* Ramp temperature down to 25 ℃ in 1 hour.
Temp.
55℃
Temp.
25℃
Temp.
Temp. 0 1
73 74
Hrs
3.3 Result :
1. Visual inspection was normal.
2. Data transmit & receive function was normal during the test.
5
4 Temperature & Humidity Test
4.1 Sample Size : 2 pcs
4.2 Test Condition :
The DUTs should be placed in the chamber to complete 6 cycle and subjected to the
following
conditions:
* Operating
Temp.
40℃
25℃
0℃
0 1
5
7
11 12
Hrs
Humidity
95 %
55%
0%
0 1
5
7
11
12
Hrs
4.3 Result :
1. Visual inspection was normal.
2. Data transmit & receive function was normal during the test.
6
5 Four Corner Test Report
5.1 Sample Size : 2 pcs
5.2 Test Condition :
* Full Loading Operation
* Chamber Temperature : 0℃ And 55 ℃
* AC Voltage : 95V And 120V
* All test procedure as follow:
5.3 Result :
Expectations : It should be no any CRC, Alignment and Oversize errors.
AC
95V
120V
-10 ℃
Pass
Pass
55 ℃
Pass
Pass
Temp
7
6 TESTING/VERIFICATION REPORT
6.1
TEST & VERIFICATON RESULT
No error found.
6.2
EVALUATION & CONCLUSION
6.3
SUGGESTION
8