6V/12V Rechargeable Battery 50/60Hz 220V / 110V AC Submersible Pump Motor - 400Gal/Hr Capacity (+) (-) Plasma Capacitor 18 Turns )+( )-( Starter Ciruit Switch B (+) 6V/ 12V DC Motor (-) Plasma Capacitor 18 Turns A MAGRAV Coil C 1 2 Plug In Load on this Power Strip Outlet Refrigerator Compressor “A” (7.7 LRA at 120v AC 60Hz) C (-) Gans inside Plastics Balls Magnetical Coil Gravitational Coil Extended Wire from Gravitational Coil PTC IN 3 R S OUT Battery Charger In: 110V/220V AC 50/60Hz Out: 6V/12V DC Legend: Gravitational Coil End (+) (-) (-) (+) Magnetical Coil End Refrigerator Unit - 1.7cu.ft Running Capacitor +Compressor “B” (0.8A 120v AC 60Hz) (+) Note: C S MAGRAV COILS Coated with CO2 bottom, CuO2 in the middle and CH3 on top R PTC G (-) M (+) (-) (-) (+) (+) Top Magrav Coils 3-Stacker Magnetical Ring - 144 Turns Gravitational Ring - 81 Turns #14 Gauge Solid Copper wire (Standard Connection) Refer to Magrav Coil Blueprint Bottom 3 2 1 CH3 Gans Coated CuO2 Gans Coated CO2 Gans Coated Energy System Gans Balls are 30 mm OD 5ml of GANS CO2 - Bottom, CuO2 - Middle, Ch3 - Top Plus Liquid Plasma in corresponding coil Use Nano-Coated Wires for Connections Starter Circuit can be removed after creating initial charge. Transfer connection from A-B to A-C Hybrid Magrav Plasma Generator Off Grid Plasma-Electrical System (Prototype Set Up) Version: 1.0 PAGE 1 OF 2 July 23, 2016 edited Aug 15, 2016 New Plasma Capacitor Design Keshe Foundation Product Innovation and Development Team June 3, 2016 edited Aug 15, 2016 (+) (-) Nano-Coated #8 Gauge Stranded Copper Wire 3 inches (-) Wax Paper with Gans+Gel (CuO2+Nano Copper Flakes) Aluminum Sheet With Gans+Gel (Composite+Nano Copper Flakes) (+) Nano-Coated #14 Gauge Copper Wire with 18 Turns Stretched up Note: Use nano coated Copper Connectors Gel = Lubricating Gel Gans = CuO2 & Composite Gans Wax Paper = Replace with Heat Resistant Paper Hybrid Magrav Plasma Generator PAGE 2 OF 2
© Copyright 2026 Paperzz