Orthotech & ScanAny
Compact
Simple
NO Casting
Lightweight
Economical
NO Mess
Accurate
Professional
NO Postage
Fast
Clean
NO Bulk
ScanAny – As easy as 1,2,3
Step 1.
 Put socks on the
patient and place the
foot in sub-talar joint
neutral.
Step 2.
 Take scan in under 2
seconds, then fill out
prescription.
Step 3.
 Email scan and
prescription to the lab.
NO MORE PLASTER
CASTING!
SAME CASTING
TECHNIQUE IN A
FRACTION OF THE
TIME.
3D ACCURACY!!
NOT 2D
Step 1.
 Place calibrated socks on
the patients feet.
 Position the foot in subtalar joint neutral (or
desired position).
 Hold the foot in desired
position, above the 4th/5th
metatarsal heads.
Step 2.
 Take scan by pressing
“Capture Still Image”
 Fill in Prescription Form
Step 3.
 Email prescription and
cast to the lab.
Taking the perfect cast

Set up your camera so that it is slightly angled
toward the medial arch of the foot, pointing upward
so that a minimal amount of data can be collected
from the posterior aspect of the heel.

The finger/thumb should be holding the foot
in sub-talar joint neutral. It should be
positioned above the 4th/5th metatarsal heads.

Imagine a line between the medial aspect
of the 1st MPJ and the medial aspect of the
heel. There should be black and white
lines lateral of this line. You can double
check this on the next screen.

The entire foot should be inside the red box
when you capture the still.
Taking the perfect cast
This image is the image
captured in its raw data.
It can be viewed from
any angle. The data
missing in the top right
corner is where the
thumb was holding the
foot in sub-talar joint
neutral (it is not
required). You can mark
a line to ensure you have
collected the data
required for the medial
arch.
For Further Information
Please Contact:
Orthotech Laboratory Pty. Ltd.
Unit 1/ Rear 194-196 Whitehorse Road
Blackburn Victoria Australia 3130
Ph: +61 3 9878 6011
Fax: +61 3 9878 7099
[email protected]
www.orthotech.com.au