GSM Pager3 Z6
Reference guide
Application of the device as a mini alarm control panel
For module version v3.10 and higher
Rev. 1.0 25.10.2011
This guide shows an example and instructions on how to use the GSM Pager3 Z6
module as a mini alarm control panel in a system with four detectors operated by remote
control.
1
Wiring diagram
2
2
Zone settings
Configure the zones according to the figure above:

from zone 1 to zone 4: normally closed (N.C.)

set the zone sensitivity to 2 tenths of a second

enter the entry and exit delay for the corresponding zone(s)

if necessary, enable 24 hour zone(s) (e.g. smoke detector, panic button
3
3
Phone number settings

Enter the user phone numbers to be notified by GSM voice call in “1…4 Phone
number” fields, then configure the confirmation method for each
(pressing key  confirms, key # stops the given event).

If the “Arm/Disarm” setting is selected at “Caller ID” option, then the user can
arm/disarm the system by free call (first call arms, next call disarms).

In “SMS forwarding 1” field enter the user phone number to which the module
should forward SMS messages received on its SIM card.
4
4
Event settings

In “T1…T4” checkboxes, enable which events should be notified by GSM voice
call to which user phone numbers. If custom voice message was recorded for the
given event, then enable this in the “Voice Msg.” column.

In “S1…S4” checkboxes, enable which events should be notified by SMS to which
user phone numbers, then enter the messages in the “SMS messages” fields.
5
5 Relay output settings

Enable “Z1…Z4 Alarm” events in “RELAY1” checkboxes, so that these events
activate the relay output.

Set the relay activation (alarming) time at “Max. ON time” option
(e.g. 240 seconds).

Enable “Beep on Arm/Disarm” option, if it is required that the siren signals on
arming and disarming.

Enable “Turn off Relay 1 on Disarm” option, so that the siren turns off on disarm,
if the system was just in alarm.
6
6
Alarm settings

Select mode 4 for “Arm/Disarm method” and enable “Arming is not allowed if
any zone is active” option.

Set the “Test report frequency” expediently to 168 hours, then at “Test report
time” option enter the time of day when the test report should be sent.

Set the “Maximum number of alarms per zone” expediently to 3-5 alarms.
7