dMT – SPC Surface Protective Coatings
dMT-SPC dry protective
coatings contain a mixture of
dMT – SPC Metallschutzprodukte auf Trockenbasis
special components (no
graphite) which create and
continually maintain an
optimal coefficient of friction
between two surfaces
Example: Block System with 5 Steel Applicators
Rotating Drum Equipment
dMT - Surface Protective Coatings System for Support Trunnions and Rings
on Kilns, Rotating Furnaces, Dryers, Mills, etc.
This picture shows a example of a SPC DRR-5.0L Block System with 5 spring-loaded, steel applicators.
The number of required blocks / applicators or size of the unit depends upon the width of the trunnions or rings to be coated.
Type TSB-085-DRR Blocks are used on supporting trunnions without a drive function.
SPC blocks are to be inserted from the rear side of each applicator.
Rotating Drum Equipment
SPC-Coatings for trunnions and tyres of rotating furnaces, kilns, dryers
(noticable „mirror
image“ on surface)
SPC-TRB-100 blocks with steel applicators
mounted against tyre surface
Rotating Drum Equipment
SPC-Coatings for trunnions and tyres, as well as thrust rollers, on rotating furnace
Rotating incinerator for hazardous waste at a chemicals production plant
DRR-T-4.0 low c.o.f. block-Kit
SPC-TRB-100 low c.o.f. block
with stainless-steel applicator type KR-RB-160