AMSTERDAM ROYAL
FRONT GENERATOR LIGHT SET-UP
WWW.ELECTRABIKE.COM
AMSTERDAM ROYAL FRONT GENERATOR LIGHT SET-UP
STEP 1: WIRING OF FRONT LIGHT
• LOCATE SOLID BLACK WIRE WITH WIRE EXPOSED END (power wire)
• THEN DEPRESS BLACK CONNECTOR ON FRONT LIGHT AND INSERT EXPOSED END
OF SOLID BLACK WIRE INTO CONNECTOR
STEP 2: GROUNDING AND ATTACHMENT OF FRONT LIGHT
• LOCATE BLACK/ WHITE STRIPED WIRE WITH BRASS EYE CONNECTOR (ground wire)
• NEXT PLACE BRASS EYE CONNECTOR BETWEEN HEX HEAD BOLT HEAD AND BRACKET.
• SECURE HEX BOLT WITH WASHER/NUT AND ATTACH TO HEADLIGHT BRACKET
USING THE SUPPLIED 10mm HEX BOLT/WASHER/NUT.
ELECTRA BICYCLE COMPANY®,LLC. • 3270 CORPORATE VIEW, SUITE A, VISTA, CA 92081
TEL 760-607-2453 • ORDERLINE 800-261-1644 • FAX 760-598-7350 • WWW.ELECTRABIKE.COM
AMSTERDAM ROYAL FRONT GENERATOR LIGHT SET-UP
= NEGATIVE
= POSITIVE
STEP 3: WIRING AND ATTACHMENT OF FRONT GENERATOR
• LOCATE WIRE GENERATOR PLUG BLOCK
• NOTE ON THE SIDE OF WIRE GENERATOR PLUG BLOCK THERE IS
FOR POSITIVE TERMINALS AND A
FOR NEGATIVE TERMINALS
SIGNALING
STEP 4: WIRING AND ATTACHMENT OF FRONT GENERATOR CONTINUED
• LOCATE SOLID BLACK WIRE WITH WIRE EXPOSED END (power wire) AND INSERT INTO
POSITIVE
TERMINAL HOLE OF GENERATOR PLUG BLOCK
• NEXT, LOCATE THE BLACK/ WHITE STRIPED WIRE WITH WIRED EXPOSED END AND
INSERT INTO THE NEGATIVE
TERMINAL HOLE OF GENERATOR PLUG BLOCK
• CONTINUE NEXT BY SNAPPING WIRE PLUG BLOCK INTO BOTTOM OF GENERATOR BODY
• CUT ANY EXCESS ENDS OF WIRE COMING OUT FROM GENERATOR PLUG BLOCK
• ATTACH GENERATOR TO FORK BRACKET USING 10mm BOLT/WASHER/NUT
• TIGHTEN BOLTS (to insure proper ground), TEST GENERATOR/LAMP AND YOUR DONE!
ELECTRA BICYCLE COMPANY®,LLC. • 3270 CORPORATE VIEW, SUITE A, VISTA, CA 92081
TEL 760-607-2453 • ORDERLINE 800-261-1644 • FAX 760-598-7350 • WWW.ELECTRABIKE.COM