Assembly Instructions for item : 3180,3181
Velo Series - 12”,18” Sconce
Important: Always disconnect the power before installing or replacing bulb and before cleaning or other maintenance.
This light should be installed by a licensed electrician
Assembly & Installation Instructions
OFF
1. Shut off power to outlet box (Fig A).
2. Make appropriate electrical connections using wire nuts:
a.Connect the fixture’s hot wire (black) to the black outlet box wire.
b.Connect the fixture’s neutral wire (white) to the white outlet box wire.
c.Connect fixture’s ground wire (green or uncoated) to the ground outlet
box wire. If no ground is present in outlet box, connect fixture’s ground
wire to the mounting plate using the green screw (included).
d. Carefully place connections in outlet box.
3. Place mounting plate over outlet box and secure it with outlet box screws.
4. Attach back plate to the back plate screws and tighten with back plate knobs.
5. Install cadelabra base bulbs.(not included)
6. Attach the plastic washer and the large glass to the threaded stem 1.
7. Attach the plastic washer and spacer to threaded stem 1 and screw until
tight,attach the plastic washer and front small glass to threaded stem 2,and
tighten with the plastic washer and knob.
8. Attach the plastic washers and side small glass to threaded stems 3 and
tighten with plastic washers and knobs.
9. Restore power to fixture.
CARE INSTRUCTIONS
Dusting – Use a clean, dry cloth.
Cleaning – To protect the finish,
avoid any harsh abrasives or chemicals.
plastic washer
threaded stem 3
OFF
3181
threaded stem 1
glass knob
side small glass
plastic washer
outlet box
plastic washer
green screw
spacer
threaded stem 2
glass knob
backplate screw
mounting plate
outlet box screw
plastic washer
backplate knob
front small glass
candelabra bulb
3180
back plate
large glass
©2011 SONNEMAN - A WAY OF LIGHT