The Touchpad control panel
…all equipment is controlled from here
touch it with your finger to start
laptop
connectors:
display,
sound,
network
when you touch the screen you’ll see:
the system takes a moment to turn on
while the projector starts.
Give it a few seconds.
•Next, you’ll see the Sources screen.
•Touch the “button” you want to display
•The “System Off” button turns everything off
when you’re finished.
laptop
vhs tape
dvd player
cable stations
(if equipped)
turn
everything
OFF
The laptop screen:
touch
system off
when done
touch sources
to change display
to DVD or VCR
control
volume
here
Mac laptops need a video adapter. Check with
the media center or bring your own.
“System Off” button turns everything off
Don’t turn off individual equipment inside cabinet
only use touchpad
You’ll see this screen while projector turns off.
No display?
May have to “re-sync” controls
1. touch “sources” (upper right)
2. select diffferent device
3. touch “sources” again, and
4. ….select original device
No sound?
• Is sound muted? Touch the mute button
(right hand side).
• Is sound turned down? Press the VOL
UP button
• Is the correct device selected? Press
“sources” upper right
Pressing too hard?
• Just kidding. You can’t really mess up
the touchpad (unless you hit it with a
hammer or throw it)
• Touch away, try things out.
• It’s as simple as we could make it. See
following screen for schedule of help
sessions.
Schedule of training sessions
when: DAILY Monday-Friday
(Aug. 27 - 31)
time: 9 AM, NOON, 3 PM
where: Media Center Classroom
(library lower level)