 Fixed-Endpoints
Fixed-Endpoints will set zero-throttle and full-throttle points
to fixed values so that the ESC does not have to learn from
your transmitter. If you are using this mode, you will most
likely want to change the EPA settings on your transmitter
to allow full throttle resolution with the throttle stick. To do
this, turn on your TX and set normal mode in the
transmitter for a linear throttle curve (0,25,50,75,100).
Bring your high side and low side endpoints on your
throttle channel down to 25%, plug in the battery pack with
the throttle stick at full (it won't start up), then bring your
high endpoint back out towards (and sometimes past)
100% until you hear a single tone. Next, bring your throttle
stick down to the bottom position and bring the endpoint
out from 25% out towards (and possibly past) 100% until
you hear the ESC arm. Unplug the battery pack, wait a few
seconds, then plug back in and verify that the throttle is
working properly.