W80 PRO CLONING PROCEDURE
1. Connect the cloning cable to the receiving radio, and turn ON the radio.
2. Rotate the main/mother radio CHANNEL to #8,then turn ON the radio with pressing and
holding the <MONI> key till the LED lights orange that means the main radio is under
cloning mode.(see manual for more info regarding KEY).
3. Press main radio <CALL> key to start cloning process. The main radio flashes red,
meanwhile the receiver flashes green. The cloning process is finished when the main radio
lights orange.
4. If you have to clone many radios, turn OFF the cloned radio (receiver) then unplug from
the data cable. Plug the next radio to be clone then press the <CALL> key of the main radio
to start cloning again.
5. Turn ON the radio again after exiting the wired clone. Then it would resume to daily
operation.
W80 CLONING PROCEDURE
1. PRESS and HOLD the alarm key(orange) BEFORE turning ON the MAIN/MOTHER radio.
(CLONING?) should be at the lcd screen of the MOTHER/MAIN radio.
2. Plug the cloning cable at both radios.
3. Turn on normally the RECIEVING radio.
4. PRESS <FUNC> key to the MOTHER radio to start cloning.
5. The receiving radio flashes red when cloning is started.
6. Wait till the receiving radio restarts and the MAIN radio will display <SUCCESS>.
UV-85 CLONING PROCEDURE
1.
2.
3.
4.
5.
CONNECT the cloning cable at both radios.
Turn ON the RECIEVING RADIO.
PRESS AND HOLD <moni> key of the MOTHER/MAIN radio then TURN on.
When cloning starts(COPING ON SCREEN), release moni.
The main Radio flashes RED while the receiving radio flashes GREEN until both radios will
restart .
6. Cloning is DONE!!
Installing Driver for UV-85, V-85 and V85PRO
1.
2.
3.
4.
Open “driver for V85 UV-85 V85PRO only”.
Choose whether your Operating system/Windows is XP, W7 or Vista then open.
Click “98ME_2k_XP” for XP, “Vista” for Vista and “Win7” for Win7.
For XP, double click “SETUP”.
For vista, double click “Vista driver installer”
For Win7, double click “vista3200_win7”
5. Set-up will start. Click “next” until finished.
1.
2.
3.
4.
Installing Driver for W80 and W80PRO
Open <driver for W80 W80PRO only>
Choose your Windows then doudle click to open.
Double click <PL-2303> to install.
Click <NEXT> until finished.
Installing Software
UV-85
1. Open UV-85 software.
2. Double click UV85CPS then click <setup> then click <ok>.
3. Click the ICON to start the installation.
V85
1. Open <V85 software>.
2. Click <V85 setup>
3. Next, next next until finished..
USB cable User Installation Manual v1.0
For Windows win7
1.Power on your computer and boot to Windows.
2.Locate the USB port of your computer and plug in the USB cable,and open Device Manager.
Windows will detect the new device (USB-Serial Controller)
3.right clik USB-Serial controller→Update Driver Software
4.select Browse my computer for driver software
5.click Browse... ,select win7 driver
.
6.click Next
7. Windows will show a dialog box, select
8. install successfully
Install this driver software anyway
7. Windows will show a dialog box, select
Install this driver software anyway
You should see the Prolific USB-to-Serial Comm Port (COM *) device listing. This also means
that
Windows has assigned the device to COM * port.