INSTALLATION INSTRUCTIONS
P-REAR-CARGO-1 W/P-MFK-11
REAR CARGO PARTITION W/FILLER PANEL MOUNTING KIT
1997-2007 CHEVROLET PASSENGER VANS
Always!
 Read all instructions before installing any Havis-Shields Equipment Corp products.
 Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
 Use hardware provided with install kit
TOOLS REQUIRED:
Power drill
Drill bit set
Standard socket set
Ratcheting wrench
COMPONENTS:
QTY DESCRIPTION#
1
Main partition frame w/ escape hatch
1
Passenger-side frame
1
Driver-side frame
2
(2)-piece upper mounting brackets
1
Mounting filler kit
P-REAR-CARGO-1
110-000210
110-000211
HS-PA99011-1
P-MFK-11
P-MFK-11 COMPONENTS:
QTY DESCRIPTION
1
Passenger side lexan filler panel
1
Driver side lexan filler panel
1
Center-ceiling filler panel
240-000168
240-000169
110-000212
HARDWARE:
QTY DESCRIPTION
5
¼” x 1 ½” Hex head lag bolt
6
¼” x ¾” Hex head lag bolt
13
¼-20 x ½” Carriage bolt
11
¼ -20 x ¾” Carriage bolt
11
¼-20 x 1” Carriage bolt
24
¼-20 Serrated nut
11
¼-20 Nylock nut
PART #
GSM33062
GSM33060-1
GSM31999
GSM32000
GSM32001
GSM30023
GSM30016
81922426
Passenger-side
lexan filler panel
(2) Piece upper
mounting brackets
Center ceiling
filler panel
Passenger-side
frame
Driver-side lexan
filler panel
Driver-side
frame
Main partition
frame
INSTALLATION:
 Unlatch rear passenger seat and move forward to allow space to place partition.
 Place main partition frame in vehicle with slide latches facing rear of vehicle.
 Attach driver & passenger-side frame pieces to main partition frame using ¼” carriage
bolts and serrated nuts.
 Partition will contour trim of vehicle and wheel wells.
 Drill 3/16” pilot holes into floor of vehicle. Check for obstructions prior to drilling.
 Loosely bolt partition to vehicle using ¼” x 1 ½” Hex head lag bolts.
 Attach (2)-piece upper mounting brackets to main partition frame using ¼” carriage bolts
and serrated nuts.
 Adjust upper mounting bracket so slots in bracket align with inner roof support under
headliner.
 Mark and pre-drill (3/16”) mounting holes in roof support. Attach upper mounting
brackets using ¼” x ¾” Hex head lag bolts.
 Tighten all loose hardware and install seat back to its original position.
81922426