DX100 Onsite Printer: Installation and Startup Guide
Contents
1.
The Installation of the DX100 Windows Driver .......................................................... 2
2.
The Installation of the SDK-P for the DX100.............................................................. 6
3.
The Adjustment of the Proper Look Up Table (LUT) ................................................. 8
4.
The Registration of the DX100 Printer (PUD-Setting)........................................................... 9
5.
The Activation of Direct Print with DX100 in assist-it............................................. 12
1
1. The Installation of the DX100 Windows Driver
A) By using the Windows Explorer navigate to the folder
‘Additional Components\Fujifilm SDK-P for DX100\Device Driver’
This folder can be found in every order-it portable update package.
Note: Please keep connect the DX100 printer and Order-it Portable at this time.
Launch the ‘Setup.exe’ application.
B) As a result the following screen is shown. Continue by pressing [Next].
2
C) Start the Installation by pressing [Install].
The installation will take a while.
3
D) As a result the following screen is shown. Continue by pressing [Next].
E) Select [I accept item of the license agreement] and press
4
[Next].
The installation will take a while.
F) Press [Finish] in order to complete the driver installation.
5
2. The Installation of the SDK-P for the DX100
A) By using the Windows Explorer navigate to the folder
‘Additional Components\Fujifilm SDK-P for DX100\Installer’
This folder can be found in every order-it portable update package.
Launch the ‘Setup.exe’ application.
B) As a result the following screen is shown. Start the Installation by pressing
[Install].
6
The installation will take a while.
C) Press [Finish] in order to complete the SDK-P installation.
7
3. The Adjustment of the Proper Look Up Table (LUT)
A) By using the Windows Explorer navigate to the folder C:¥PUD¥TOOL¥DX100
This folder is created during the installation of the SDK-P.
B) Launch the ‘¥Printer Profile1.bat’ batch command
For a very short moment a console window is displayed. Afterwards, the proper LUT
for the DX100 is adjusted.
C) Please restart DPC-Potabel
8
4. The Registration of the DX100 Printer (PUD-Setting)
A)
By launching ‘ C:\PUD\PUD_Setting.exe ’ within the Windows Explorer
B) In the login dialog enter “0000” as password and click the [OK] button.
9
C) Click into the line ‘A’ of the ‘printer’ column even it is empty (see screenshot).
Note: This is an important step! Please be careful to click exactly in the area which is read
marked above!
D) As a result a message box is displayed.
10
E) Select the connected printer into the combobox and press [OK].
F) Finally, click the [OK] button in order to terminate the program.
G) The following box will appear:
11
5. The Activation of Direct Print with DX100 in assist-it
A) Please start assist-it
B) Please select the '3. Configure output devices'.
12
C) Please put check in the 'Onsite printer DX100'.
Note: Press ' Onsite printer DX100' button, set the print size, etc.
13