FIXING SYSTEMS/PRECAST TECHNOLOGY
OPTIFIX/OPTIFIX-HW
Optifix
Optifix-HW 12
Features
Threaded sockets made of high-grade plastic for the attachment of e.g. braces with precast elements
Ribbed design ensures good anchoring in the concrete
Optifix - W with fixing plate for adhesion to steel formwork
Test of pull-out load capacity available
PRODUCT DATA SHEET
PRODUCT DATA SHEET
Optifix/Optifix-HW
Optifix
APPLICATION
Fixing dowel made of high-grade plastic with inner thread.
INSTALLATION
Optifix is fixed to the formwork using e.g. plastic nailing plate, fixing plate for
adhesion or snap off fixing plug.
Optifix
IMPORTANT
Optifix should only be used for light, temporary fastening. If steel fastening
screws should be used, care must be taken that the length selected is not
too long as otherwise the dowel might be twisted off.
Plastic nailing plate
Snap off fixing plug
ORDER INFORMATION
Item no.
Type
For thread
20585
M8
M8
Length (mm)
Packaging (pcs.)
20586
M10
M10
36/40
500
20587
M12
M12
60/65
500
20588
M16
M16
55/60
500
20588
Plastic screw
M10
Length = 55 mm
500
500
PRODUCT DATA SHEET
Optifix/Optifix-HW
OPTIFIX-HW 12
APPLICATION
Dowel made of high-grade plastic with inner thread for fixing braces in
place. Thanks to its low height, the Optifix-HW is particularly suitable for
precast cavity wall elements. The moulded fixing plate can be removed
easily after formwork removal thanks to its pre-determined breaking point.
Optifix-HW
INSTALLATION
Optifix-HW is glued to the formwork.
IMPORTANT
The fastening screws must not be chosen too long since otherwise the
dowel may be twisted off. When using a cordless screwdriver, be careful not
to overturn the Optifix-HW.
Item no.
20589
20590
20591
20591-01
20899
Type
Optifix-HW 12
Wood screw 12 x 70
(according to applicable regulations) galvanised
Washer ZN 13
(according to applicable regulations) galvanised
Cover (grey) for Optifix-HW 12,
diameter = 65 mm for covering the screw opening
Optifix-HW 12 with pre-mounted plug
Thread diameter
Packaging (pcs.)
M 12
250
50
50
500
on request
250
Please observe the safety notes on our current catalogue.
We reserve the right to make technical changes
General note: In our opinion, this information is the best that can be given on this subject at this point in time. We are providing you with this information as
a potentially helpful suggestion for any similar checks you intend to undertake. The information is subject to review as soon as new knowledge is available.
Reuss-Seifert does not accept any guarantee or liability connected with this information.
Reproduction – even in part – only with written approval from Reuss-Seifert GmbH
ORDER INFORMATION
Wuppertaler Straße 77 · 45549 Sprockhövel · Germany
Tel. +49 2324 9046-0 · Fax +49 2324 9046-112
[email protected] · www.reuss-seifert.de
02/2017
Reuss-Seifert GMBH