Assembly Instructions
Leaf Lamp Tree 230
Peter Schumacher
Included Parts
Felt Pad
x 500
Bolt
x8
Small Branch
x 500
Screw (A)
x5
Medium Branch
x 100
Screw (B)
x4
Large Branch
x 20
Ring
x1
Screw (C)
x2
XL Branch
x4
Tree
x1
Foot
x1
Cord
7m
Instructions
1
Put some glue on a paper and role the
branches ends in it. You don’t need much!
Glue should be applied on the Small and
Medium Branch.
2
Insert the Small Branches into the Felt
Pads with a bit pressure.
3
4
1
2
4
Insert the Small Branch into the holes on
the Medium Branch with a bit pressure.
5
3
5
Repeat to fill up the branch with leaves.
6
1
1
Insert the Medium Branch into the top
hole on the Large Branch.
7
Make sure the leaf-stick closest to the
branch is pointing upwards.
8
2
4
3
5
Repeat step 3 and 4 on the four branches
closest to the top.
Insert the lowest branch and make sure
the Small Branch closest to the branch is
pointing downwards.
9
1
Insert the Large Branch into the XL
Branch.
10
1
Front view
45°
Side view
Make sure the Medium Branch (marked with green) closest to the XL Branch is pointing
downwards to the left (45 degrees clockwise from an outer view).
Fasten the branch with Screw (A).
11
12
2
4
3
5
Repeat step 9 and 10 on the remaining
branches and pay extra attention on the
inserting angle.
Make sure no leaves are closer then 3 cm
to the lamp. If so, cut away those leaves.
13
14
Insert the tree into the Foot, and put the
Bolts in place.
Taighten the Bolts with various strength in
order to fine tune the angle.
15
Insert all XL Branches into the Tree. Start with the top branch. You might have to test different
inserting angles in order to make everything fit. Fasten the branches with Screw (B).
16
To make the cut in the Tree stay as taight
as possible, put the ring over the top of
the Tree and taighten with Screw (C).
17
As a final step, let a certified electrician install the electrical components and let the Cord
follow the cut on the tree from top to bottom.
Enjoy the greener environment!
www.greenfurniture.se