New Sliding Door Spec.
Sliding Doors
Sliding doors available in Two, Three and Four door runs
3 Panel
Full colour
Panel
or Etched
mirror
Contemporary
split
5 Panel
The image above shows the four different sliding doors panel
configurations that are available.
The track and sliding door metal frame colour is available in a silver
or matt black finish
As standard the sliding doors will include:
 2, 3 or 4 equal sized sliding doors and track (See important
notes)
 2, 3 or 4 stock carcase robes 595mm deep inc backs
 1 x Full width 100mm front frame (see important notes)
 A third track and guide on all angled doors
 Any combination of MFC and glass panels as detailed above
(see important notes)
It is important to note:
1. Door sizes cannot be mixed.
2. 600,800, 900,1000 and 1100mm wide
3. If customer chooses 1100mm wide doors, it must be a 500 and a 600
wide carcase robe behind them. If customer insists it has to be 1100
wide it has to be front frame, IF THEY INSIST CARCASE WE CAN
CUT DOWN A 1200mm CENTER PACK, YOU MUST CHARGE
EXTRA FOR THE FITTER AND SALES MUST CHARGE FOR A
1200mm ROBE.
4. If the 100mm MFC frame is over 2700mm wide it will have the sliding
door track and MFC frame jointed in the middle.
5. Where any MFC frame is jointed in the middle, no guarantee can be
made that any wood grain finish will match at the joint
6. All panel colours must be clearly stated and specified as glass or MFC
7. Internal colour is Beech only
8. Any sliding door panel that has an angled cut can only be supplied in
MFC and NOT GLASS
9. The minimum width that must be left at the top of any angled door
is 200mm
10. The minimum height that must be left below the angle of any sliding
door is 900 mm from the floor
11. Due to the height of the third track that is fitted behind any angled
sliding door, there must be no internal drawer fitments fitted
12. If one sliding door is angled then a three door run must be used
13. If two sliding doors are angled the a four door run must be used
14. The door configuration of a four door sliding run, that has outer angled
doors must have alternate doors fitted on the track as shown in the
image below
15. Where an etched mirror door is supplied, the etching width will be 600
mm wide regardless of actual door width
Floor plan showing sliding door configuration when angled doors are used. Doors must
be fitted alternate on front and rear tracks
DOOR RANGE
SLIDING WARDROBES
DOOR STYLE
DOORS ARE IN AN ALUMINIUM OR MATT BLACK FLAME.
DOOR COLOUR AVAILABLE
WALNUT
PUTTY
NOCINO
METALIC SILVER
BEECH
TANGERINE
MAPLE
SCARLET
LIMED OAK
PLUM
DÉCOR CREAM
MULBERRY
SOFT WHITE
PASTEL GREEN
FROSTED GLASS
LIME ZEST
WHITE GLASS
SKY BLUE
BLACK GLASS
DARK BLUE
MID-SHEEN CREAM
MIRROR
MID-SHEEN BLACK
CHOCOLATE
MID-SHEEN WHITE
CAPPUCCINO
ETCHED MIRROR
WE CANNOT DO THE PANELS WITHIN THE DOORS IN ZEBRANO.
EXTERNAL CABINET COLOUR BEECH
MAPLE
LIMED OAK,
WALNUT
NOCINO
GLASS
MID-SHEEN WHITE
MID-SHEEN CREAM
ZEBRANO
DÉCOR CREAM
SOFT WHITE
INTERNAL FRAME COLOUR
BEECH ONLY
FEATURE DOORS
AS ABOVE
PLINTHS / SKIRTING
SQUARE EDGED MFC
CORNICE
BULLNOSE, MODERN or FLAT.
IF FRAME IS ZEBRANO OR MID-SHEEN, ONLY 18mm CANOPY
AVAILABLE.
TOPS
NOT AVAILABLE
COMMENTS
1) ALL ADDITIONAL CABINETS TO BE CALLED OFF AS PER
EXISTING RANGES
2) CAN BE ANGLED ON A FRAME SYSTEM ONLY
3) CAN BE REDUCED IN HEIGHT
(100mm increments, minimum is 1800mm door on a 1903mm frame)
ON A FRAME SYSTEM ONLY, OR CARCASE CAN BE REDUCED
IN HEIGHT AT AN EXTRA COST FOR THE FITTER.
4) CAN BE INCREASED IN HEIGHT
(100mm increments, maximum is A 2400mm door on a 2503mm frame)
ON A FRAME SYSTEM ONLY
AVAILABLE IN 600,800, 900,1000 OR 1100 DOORS ONLY.
PLEASE CHECK THE SLIDING DOORS CAN GO UP THE CUSTOMERS STAIRS!!!!
SLIDING DOOR SYSTEM
QUICK REFERENCE GUIDE
SIZES AVAILABLE: - 600,800, 900, 1000 & 1100 ONLY
2 DOOR CONSISTS OF 2 X STOCK 600,800, 900 or 1000 WIDE WARDROBES
3 DOOR CONSISTS OF 3 X STOCK 600,800, 900 or 1000 WIDE WARDROBES
4 DOOR CONSISTS OF 4 X STOCK 600,800, 900 OR 1000 WIDE WARDROBES
1100 WIDE DOORS MUST HAVE A 500 AND A 600 WARDROBE BEHIND
THEM.
(IF CUSTOMER DOESN’T WANT THIS IT HAS TO BE AN 1100 FRONT
FRAME, OR WE CAN CUT DOWN A 1200MM CENTER PACK BUT YOU
MUST CHARGE EXTRA ON THE FIT SHEET AND CUSTOMER MUST BE
CHARGED FOR A 1200 ROBE)
ROBE DOOR WIDTHS MUST BE EQUAL AND CAN NOT BE MIXED
THE SYSTEM CONSISTS OF:2, 3 or 4 STOCK CARCASE ROBES 595 DEEP INC BACKS
1 X FULL WIDTH 100mm FRONT FRAME, IF FRAME IS BIGGER THAN
2780mm IT WILL HAVE A JOINT IN THE TOP AND BOTTOM.
2, 3 or 4 EQUAL SIZED SLIDING DOORS EACH MADE UP WITH 1, 3 or 5
PANELS
595 DEEP ROBES + 100 FRONT FRAME = OVERALL DEPTH 695mm
CARCASE ROBES ONLY AVAILABLE 2203 H
SLIDING DOORS CAN BE ANGLED, INCREASED OR DECREASED IN
HEIGHT IN 100MM INCREMENTS.
MAXIMUM HEIGHT 2503mm FRAME/2400mm DOOR
MINIMUM HEIGHT 1903mm FRAME/1800mm DOOR