Interface Connected
Configuration
Current
-
4.2 mA
2 wired inputs
11,9 mA
-
12.4 mA
2 wired inputs
20,1 mA
-
10.4 mA
2 wired inputs
18,1 mA
Slide Control
15.6 mA
2 wired inputs + Slide Control
23,3mA
-
12.2 mA
2 wired inputs
19,9 mA
Slide Control
16.6 mA
2 wired inputs + Slide Control
24,3 mA
-
15.6 mA
2 wired inputs
23,3 mA
Slide Control
19.9 mA
2 wired inputs + Slide Control
27,6 mA
None
1 Pushbutton
2 pushbuttons
4 pushbuttons
6 pushbuttons
















There are eight Scenes available for acting on the enabled objects within “Internal Scenes”.





Action on Hold Pressing:







Range of Values
Function
Not Used
No Action.
Stop Dimmer (Default)
Assigns an increase or decrease of 0% to “Dimmer – Relative Dimmer”, depending on the last function
performed.


Action on Hold Pressing:










Communication Objects:






Turn Primary Off
Toggle Secondary
Assigns OFF to “SW – Primary”.
If “SW – Secondary” is OFF, assigns it the value ON.
If “SW – Secondary” is ON, assigns it the value OFF.
Turn Secondary On
Assigns ON to “SW – Secondary”.
Turn Secondary Off
Assigns OFF to “SW – Secondary”.
Range of Values
Function
Not Used
No Action.
Toggle Primary
If “SW – Primary” is OFF, assigns it the value ON.
If “SW – Primary” is ON, assigns it the value OFF.
Turn Primary On
Assigns ON to SW – Primary.
Turn Primary Off
(Default)
Assigns OFF to SW – Primary.
Toggle Secondary
If “SW – Secondary” is OFF, assigns it the value ON.
If “SW – Secondary” is ON, assigns it the value OFF.
Turn Secondary
On
Assigns ON to SW – Secondary.
Turn Secondary
Off
Assigns OFF to SW – Secondary.






Range of Values
Function
Not Used
No Action.
Turn On
Assigns ON to Dimmer – ON/OFF.
Turn Off
Assigns OFF to Dimmer – ON/OFF.
Increase
Assigns to Dimmer – Relative Dimmer. Increment in % set as parameter in “Percentage to Increase/Decrease”.
Decrease
Assigns to Dimmer – Relative Dimmer. Decrement in % set as parameter in “Percentage to Increase/Decrease”.
Toggle & enable Slide Control
If “Dimmer – ON / OFF” is OFF, assigns it the value ON and the “Dimmer – Absolute Dimmer” object is associated with the
Slide Control, enabling definition of the load value via the Slide Control.
If “Dimmer – ON / OFF” is ON, assigns it to OFF and clears the association of “Dimmer – Absolute Dimmer” from the Slide
Control.
The duration of the association is determined by the Slide Control configuration
Enable Slide Control
The “Dimmer – Absolute Dimmer” object is associated with the Slide Control, enabling definition of the load value via the
Slide Control.
The duration of the association is determined by the Slide Control configuration
Stop Dimmer (Default)
Assigns to Dimmer – Relative Dimmer. Increase or Decrease 0% depending on whether it was increasing or decreasing.



Stop
Assigns the Increase/Decrease (Step Down/Up) value to “Blinds – Step/Stop”, depending on the last movement of the blind.
Slats Up/step
Assigns the Decrease (Step Up) value to “Blinds – Step/Stop”.
Slats Down/step
Assigns the Increase (Step Down) value to “Blinds – Step/Stop”.

