Drawing Abilities Teacher
Dimensioning
© J Lewis 2004
General Principles
A drawing should provide a complete set of instructions for making a
component.
Dimensions define geometric characteristics such as
•Angles
•Diameters
•Lengths
•Positions
Each dimension which defines a characteristic of the component appears only
once.
Dimensions should not have to be worked out by addition or subtraction of
other dimensions.
© J Lewis 2004
British Standards
A - The drawing outline should be drawn with 0.7mm thickness.
B - Dimension and projection lines are thin continuous lines 0.35mm thick.
C - All dimension lines are clearly placed outside the outline of the drawing.
D - The projection lines should not touch the drawing but a small gap should be left.
E - The projection lines should continue past the dimension line.
F - Arrowheads should be triangular and of uniform size and shape and filled in.
G - Arrowheads must touch the projection line to which they refer.
26
A
C
D
E F
40
Dimension Line
Projection
B Line
C G
© J Lewis 2004
British Standards
So that dimensions can be read clearly, figures must be placed so that they can be
read from the bottom of the drawing or so that they can be read from the right hand
side when the drawing is rotated clockwise.
Always write 0.4 and not .4, also note that the decimal point is on the base line
between the figures and that dimensions are quoted in millimetres to the minimum
number of significant figures eg 21 and not 21.0.
Note that the correct line type must always be used.
Hidden detail is shown by a thin dashed line with dashes of consistent length and
spacing.
A centre line is a thin chain line ( with alternate short and long dashes ) which is
used to indicate the axes of holes, components and circular parts.
A detailed look at the British Standards manual is definitely worthwhile to see the
rules which govern drawings – these may seem to be very tedious but will make
your drawings a pleasure to use.
© J Lewis 2004
General Rules
H - Begin by dimensioning the view which gives the clearest understanding of the
component shape.
I - Place dimensions outside the shape of the component wherever
possible.
J - Position the shortest dimension nearest to the component to prevent
dimension lines crossing.
K - Use a similar spacing between dimension lines to ensure a neat diagram.
I
8
H
J
2
Plan
10
28
16
26
J
J
32
40
End Elevation
Elevation
K
End Elevation
© J Lewis 2004
L - Measure horizontal sizes from left to right and write the distance on top of the
dimension line. Angled sizes are shown in a similar manner to horizontal sizes.
M - Measure vertical sizes from bottom to top and write the distance vertically to the
left of the dimension line.
N - Small sizes are shown with the arrows placed outside.
O - Place the largest sizes on the outside of the dimensional grid.
P - Sizes from a datum line are logically set out.
Plan
2
10
8
28
N P
16
26
O
L
End Elevation
M
32
40
Elevation
End Elevation
© J Lewis 2004
Dimensioning Circles
Dimension circles as shown. Holes are always dimensioned as diameters.
Ø 80
Ø
80
80
Ø
80
© J Lewis 2004
Dimensioning Angles
Dimension angles as shown.
14
°
45°
106°
106°
© J Lewis 2004