For protection against
Ants, Cockroaches, Fleas,
Flie, Mosquitoes, Spiders
HomeRun
TM
Insecticide
HomeRun
TM
Insecticide
Key Industries Ltd
3/44L Constellation Drive PO Box 65-070
Mairangi Bay, Auckland 0754
Tel 09 917 1791 0800 539 463 Fax 09 9171793
Email [email protected]
Web www.keyindustries.co.nz
www.keyindustries.co.nz
ALWAYS READ THE LABEL BEFORE USE
HomeRun
Active Ingredient
Formulation
Pack size
Comatibility
TM
50g/litre alpha cypermethrin
Suspension Concentrate
1 Litre
HomeRun is compatible with most pest control products such as IGR insecticides and additives such as Sprayfast.
General Information
HomeRun is a residual insecticide for the control of ants,
cockroaches, fleas, flies, mosquitoes and spiders in domestic,
industrial and public health areas.
HomeRun has both knockdown, residual and repellent activity
against most insect species. Repellent activity may prevent
insects coming into contact with residual deposits of
HomeRun.
HomeRun works through a variety of means:
• Contact: Contact via a direct spray with HomeRun kills
quickly. However most insects will not deliberately crawl
over, or land on residual deposits of HomeRun.
As the residual deposit wears off so does the effect of the
repellent and insects become more inclined to crawl over
or land on repellent activity treated surfaces.
• Residual: HomeRun provides a protective residual barrier
on treated surfaces for several weeks.
• Repels: HomeRun repels insects from crawling over or
landing on treated surfaces. For this reason it should not
be used in conjunction with a baiting programme.
HomeRun is a high quality suspension concentrate formulation with a very small particle size for optimum contact with
insects. 90% of the active ingredient particles are smaller than
10 microns in diameter. HomeRun is suitable for treating all
surfaces and gives improved residual activity compared to EC
insecticide formulations on porous surfaces such as unpainted brick, concrete block, timber or fibrous cement.
Directions for use:
Situation
Insect Pest
Rate
Critical
Comments
Houses, flats.
factories, shops,
warehouses, restaurants, meat and
dairy processing
plants.
Ants, cockroaches,
fleas, flies, mosquitoes and spiders.
Initial Treatment:
50ml in 5 Litres of
water.
Apply as a spray at
the rate of 5 Litres
per 100 square
metres or to the
point of run-off,
which will vary
with the nature of
the surface being
treated. if lower
rates or if misting
equipment
(eg B&G 2600 or
Pioneer ULV) is
used, the dilution
rate should be
adjusted so that
50ml HomeRun
is applied per 100
square metres.
Maintenance treatments: 25ml in 5
litres of water.
MPI Approved type B (all animal products except dairy)
AsureQuality approved Category C Food/Beverage/
dairy factory and storage areas (Category B point apply)
Where to apply:
Ants: nests, runs, walls, drains and wherever ants are seen.
Cockroaches: cracks and crevices, walls, skirting boards, cupboards,
behind sinks, stoves and pipes.
Fleas: floors, carpets, skirting boards, kennels, animal bedding and
adjacent wall area.
Flies and Mosquitoes: walls, ceilings, skirting boards and all exposed
surfaces where flying insects may rest.
Spiders: nests and known hiding places, and exposed surfaces where
spiders are seen.
Important - Food Contamination
•
Do not allow spray to contact food, food preparation surfaces or
food utensils.
•
Remove or cover all foodstuffs before application.
•
Do not use in areas where edible dairy or meat products are processed, packed or stored.
•
Do not use where food packaging materials (cartons, liners etc)
are stored or assembled.
•
Do not use near air vents or ducts in food stores or processing
plants while they are in operation.
•
Wash all food contact surfaces thoroughly before reintroducing
any foodstuffs.
Caution: Spray applicators should take precautions to avoid contact
with concentrated spray or spray solution by wearing gloves, eye protection, long-sleeved overalls and facemask.
HomeRun may cause a burning sensation (parathaesia) if it contacts
the skin or eyes.
When HomeRun is used via misting equipment, the spray should be
surface applied and not directed into the air. For all applications at least
3 hours should be allowed before re-entry after spraying. This allows for
thorough ventilation and any airborn spray particles to settle.