1
PREPARING
C – SILICONES
PREPARING SILOFLEX PLUS
2
Easy processing
Easy dosage, short mixing time, easy check of
homogeneously mixed material with colour contrast catalyst
PREPARING SILOFLEX PLUS PUTTY
dosage
 dose putty material using measuring spoon
 impress the edge of the spoon into the selected putty
 2 strand-lengths of the catalyst (8 cm) per 1 spoon
An excess amount of catalyst shortens the working
and the setting times.
3
PREPARING SILOFLEX PLUS PUTTY
mixing
4
45 s
 knead the substance thoroughly to achieve a homogeneous
colour without pink stripes
!!! Work in protective gloves only !!!
Method of double impression
PUTTY APPLICATION
Application
Inserting into
on the tray
the mouth
Impression
Outlet holes
cutting
5
PUTTY
6
PREPARING SILOFLEX PLUS LIGHT
dosage
1:1
mixing
30 s
 mix until a homogeneous colour is achieved, spread
thoroughly along the pad to achieve a smooth consistency
without bubbles
7
Method of double impression
LIGHT APPLICATION
Applying Light to the tray
Inserting and fixing in the
mouth
8
Method of double
impression
9
IMPRESSION - PROCESSING
 Impression - disinfection
Disinfection in standard disinfection solution (e. g.
Jodisol diluted with water at a ratio of1:10)
 Store the impression at room temperature (up to 25 ºC)
 Plaster can be placed in the impression 30 minutes from
removal of the impression from the mouth
 There are no time limitations, but it is recommended to
cast within 4 hours.
10
PREPARING SILOFLEX PLUS
Mistakes in preparation
 non-homogeneous mixing – it can cause a foliated
impression
Too quick setting, resp. no setting due to mixing
ratio
Bad reproduction – impression at the end of working
time
11
12
Thank you for your
attention!