Test Scenario 1: Clearing existing folder with assigned to Test cycle.
Before the clearing:
After clicking on Clear assigned cycle, received the following:
After clicking OK, it clears everything and above dialog box remains, I had to click twice
to get rid of it.
Scenario 2: Adding new folder and test cycle:
Right after I created on the new folder I get message: ( this happens if I click on any
folder)
Assigning cycle by selecting from drop down, received above message and clicked ok
twice. Cycle was added successfully.
Assigning tests sets to folder: received above message click ok and was prompted to add
name of test set: added name and click, then received same message, click ok twice and
test set was created. Added one test
Now proceeding with clearing by clicking on folder which brings message box and then I
clicked ok. It disappeared.
Clicked on clear Assigned to cycle. Got same message, clicked on ok , it clears
everything and message box remains, clicked ok again twice, but it does not reset to
original values.
Key observation:
Message being displayed, but resetting to original is not happening.
Also Message should not be displayed by clicking on every folder.