Von Neumann architecture

SHRI S’AD VIDYA MANDAL
INSTITUTE OF TECHNOLOGY
Introduction to AVR ATMega32
Architecture
PRESENTED BY: BIND LALSHA 130450112003
INTRODUCTION TO ATMEL AVR
• The AVR architecture was conceived by two students at the
Norwegian Institute of Technology (NTH) Alf-Egil Bogen and
Vegard Wollan.
• The AVR is a modified Harvard architecture 8-bit RISC single
chip microcontroller which was developed by Atmel in 1996. The
AVR was one of the first microcontroller families to use on-chip
flash memory for program storage, as opposed to one-time
programmable ROM, EPROM, or EEPROM used by other
microcontrollers at the time.
• The AVR is a modified Harvard architecture machine where
program and data is stored in separate physical memory systems
that appear in different address spaces, but having the ability to
read data items from program memory using special instructions.
• "
HARVARD ARCHITECTURE
Howard Hathaway Aiken
 The Harvard architecture is a computer
architecture with physically separate storage
and signal pathways for instructions and data.
 The term originated from the Harvard Mark I
relay-based
computer,
which
stored
instructions on punched tape (24 bits wide) and
data in electro-mechanical counters.
 In a Harvard architecture, there is no need to make the two memories
share characteristics. In particular, the word width, timing,
implementation technology, and memory address structure can differ. In
some systems, instructions can be stored in read-only memory while data
memory generally requires read-write memory. In some systems, there is
much more instruction memory than data memory so instruction addresses
are wider than data addresses.
VON NEUMANN ARCHITECTURE
John von Neumann
 In contrast with the Harvard architecture, the
Von Neumann architecture has a single
storage structure to hold both instructions and
data. The CPU can be either reading an
instruction or reading/writing data from/to the
memory because instructions and data use the
same bus system.
 The phrase Von Neumann architecture derives name of the mathematician
and early computer scientist John von Neumann.
 The meaning of the phrase has evolved to mean a stored-program computer
in which an instruction fetch and a data operation cannot occur at the same
time because they share a common bus. This is referred to as the Von
Neumann bottleneck and often limits the performance of the system.
MODIFIED HARVARD ARCHITECTURE
A modified Harvard architecture machine is very much like a Harvard
architecture machine, but it relaxes the strict separation between instruction
and data while still letting the CPU concurrently access two (or more) memory
buses. The most common modification includes:
• Separate instruction and data caches backed by
acommon address space. While the CPU executes from
cache, it acts as a pure Harvard machine. When
accessing backing memory, it acts like a von Neumann
machine (where code can be moved around like data, a
powerful technique). This modification is widespread
in modern processors such as the ARM architecture
and X86 processors.
• Provides a pathway between the instruction memory (such as ROM or flash) and the
CPU to allow words from the instruction memory to be treated as read-only data. This
technique is used in some microcontrollers, including the Atmel AVR. This allows
constant data, such as text strings or function tables, to be accessed without first
having to be copied into data memory, preserving scarce (and power-hungry) data
memory for read/write variables. Special machine language instructions are provided
to read data from the instruction memory. (This is distinct from instructions which
themselves embed constant data, although for individual constants the two
mechanisms can substitute for each other.)
PROCESSOR ISA: RISC VERSUS CISC
CISC
Emphasis on hardware
RISC
Emphasis on software
Include multi-clock complex instructions Include single-clock reduce instruction
only
Memory-to-memory: “Load” and “Store”
incorporated in instructions
Register-to-register: “Load” and “Store”
are independent instructions
Small code sizes, high cycles per second
Low cycles per second, large code sizes
Transistors used for storing complex
instructions
Spends more transistors on memory
registers
•
RISC vs. CISC is a topic quite popular on the Net. Every time Intel (CISC) or
Apple (RISC) introduces a new CPU, the topic pops up again.
•
Most PC's use CPU based on CISC architecture. For instance Intel and AMD
CPU's are based on CISC architectures.
•
Many claim that RICS is the architecture of the future.
•
But even though RISC has been in the market since 1980, it hasn’t managed to
kick CISC out of the picture, some argue that if it is really the architecture of
the future it should have been able to do this by now.
ATMEGA32 PIN OUT & DESCRIPTIONS
Clears
all the
Port
B
registers supply
and
Provides
restart the
voltage
to the
These
pins
are
execution
of
chip.
It should
used
to connectto
beprogram
connected
external+5
crystal
or RC oscillator
Port D
Port A
Reference
voltage
ADC
Supplyfor
voltage
for ADC and
portA. Connect
it to VCC
Port C
ATMEGA32 PIN OUT & DESCRIPTIONS
ATMEGA32 PIN OUT & DESCRIPTIONS
ATMEGA32 PIN OUT & DESCRIPTIONS
Digital IO is the most fundamental mode of connecting a MCU to
external world. The interface is done using what is called a PORT. A
port is the point where internal data from MCU chip comes
out or external data goes in. They are present is form of PINs of
the IC. Most of the PINs are dedicated to this function and other pins
are used for power supply, clock source etc . ATMega32 ports are
named PORTA, PORTB, PORTC, and PORTD.