Shown In
Locked Position
Shown in
UnLocked Position
Rev.
Description
Initiator
Date
01
Initial Drawing
JDB
03/15/2012
02
ECO 9590;
JDB
06/28/2012
90° Swing
Note 4
Adjustable
Arm
222/25 inlbs
Note 5
3415-0021022-00
Rotary Actuator
10mm Stroke
Lock/UnLock
Sensors
31.5 Ref
Locked
13
49 Ref
UnLocked
7.5 Closed
3405-2220005-01
2X Air Fitting M5
7649-569
Contact
+ 1/4 Turn
12
29.5
Note 1,2,3
UnLock Sensor
(Mark Wire with
Red Tape)
Front View-Locked
3700-20-7335
Actuator Mounting
Bracket
3500-10620120-15A
4X M4 x 12mm SHCS
Pre / 25 in-lbs
1.
2.
3.
4.
5.
Side View-UnLocked
Brown: +10-30 VDC
Black: Signal
Blue: 0 VDC
3500-1062010-15A
3X M4 x 10mm SHCS
Pre 25 in-lbs
Notes:
Lock Sensor
(Mark Wire with
Green Tape)
Prox Wiring
1031 Goodworth Drive, Apex, NC 27539, USA
Tel: +1.919.772.0115 Email: [email protected]
Fax: +1.919.772.8259 www.ati-ia.com
ISO 9001 Registered Company
NOTES: UNLESS OTHERWISE
SPECIFIED.
DO NOT SCALE DRAWING.
ALL DIMENSIONS ARE IN
MILLIMETERS.
Move sensors to position shown and tighten screw using flat head screw driver.
Install sensors on proper side as shown.
Wire tie loose wires.
Loosen SHCS to rotate arm into correct position, torque 25-31 in-lbs.
Adjust arm to dimension shown. Lock in place with Lock Nut.
PROPERTY OF ATI INDUSTRIAL AUTOMATION, INC. NOT TO BE REPRODUCED IN ANY
MANNER EXCEPT ON ORDER OR WITH PRIOR WRITTEN AUTHORIZATION OF ATI.
DRAWN BY:
CHECKED BY:
3rd ANGLE PROJECTION
PROJECT #
JDB, 12/27/11
TITLE
Clamp Module, RH
JW, 4/30/12
110516-1
SHEET 1 OF 1
SCALE
SIZE
DRAWING NUMBER
1:2
B
9630-20-TSS-CM-7335
REVISION
02