easy
the
YARN
one ball
one beanie
What you’ll need:
• 1x 100g ball ‘Moda Vera’ One Ball One
Beanie (Quantities are approximate as they
vary between knitters)
• One pair 7.00mm (UK 2) knitting needles,
or size required to give correct tension.
• Wool needle.
Measurements
To Fit Head (approx) cm 56-59
TENSION
12 sts and 17 rows to 10cm over stocking
st, using 7.00mm needles.
To work a 15cm x 15cm tension square,
using 7.00mm needles cast on 18 sts.
Work 26 rows stocking st. Cast off loosely.
Check your tension carefully. If there are less
sts to 10cm use smaller needles, if more sts
use bigger needles.
ABBREVIATIONS
Approx = approximate/ly, beg = begin/ning,
cm = centimetres, cont = continue, K = knit,
P = purl, sl = slip, st/s = stitch/es, stocking
st = 1 row K, 1 row P, psso = pass slipped
st over, RS = right side, rem = remain/ing,
rep = repeat/ing, tog = together, WS =
wrong side.
beg, ending with a 2nd row.
BEANIE
Using 6.50mm needles, cast on 69 (77) sts.
Work 3 rows rib.
1st row (RS) – K2, * P1, K1, rep from * to
last st, K1.
2nd row – K1, * P1, K1, rep from * to end.
Shape Crown –
1st row – Rib 5, * sl 1, K2tog, psso, rib 5,
rep from * to end … 53 (59) sts.
Work 3 rows rib.
5th row – Rib 5, * sl 1, K2tog, psso, rib 3,
rep from * to end … 37 (41) sts.
9th row – Rib 1, * sl 1, K2tog, psso, rib 1,
rep from * to end … 19 (21) sts.
Work 1 row rib.
Last 2 rows form rib.
11th row – Rib 1 (0), * sl 1, K2tog, psso, rep
from * to end … 7 sts.
Cont in rib until work measures 18cm from
Break off yarn leaving a long end.
The information on this project sheet is presented in good faith, but no warranty is given, nor results guaranteed.
Quantities and selections may vary at each store. Spotlight cannot guarantee results. Copyright Spotlight 2013.
Run end through rem sts, draw up tightly
and fasten off securely.
TO MAKE UP
DO NOT PRESS. Using mattress stitch, join
side seams tog to form back seam. Sew in
ends.