Instruction of Update
Request:


PC with winows 7
USB cable
Steps:
1. Set the computer to test mode: go to "start" -- "accessories" -- "command prompt"(run as
administrator)
2. Input "bcdedit /set testsigning on", then press enter -- restart the computer.
3. After restart, you’ll see this above notification bar
4. Decompress the firmware file
5. Decompress the driver file "driver For OPPO Find 5"
6. Open the firmware file -- "Download_Development"(run as administrator),
7. check "selectall" -- “Start Download”
8. power off the phone -- > press volume+ key (don’t release until connect to computer) ->connect it to computer -- > release volume+ key -- > then go to device manager of PC -install the driver manually
9. when finished, you'll see port “Qualcomm HS-USB QDLoader 9008” turned into “Qualcomm
HS-USB Diagnostics 9006”. Then download will begin，you can see progress bar in
"download development" is moving.
10. After about 3 min, you'll see a green notification, which means the download is finished. Long
press the power key for about 10 seconds to start the phone.