Most Kwik Goal products carry a Lifetime Guarantee. For details or
claims, visit kwikgoal.com or contact customer service at 1-800-531-4252.
ASSEMBLY INSTRUCTIONS FOR 2J102 RUGBY GOAL
1. Unpack all parts and check for damage that may have occurred during shipping. If damage has occurred,
notify trucking company immediately. Lay out all parts. Remove all cardboard and packaging immediately.
Wet or damp packaging may damage contents.
2. Read through entire instruction before beginning assembly and installation.
3. This equipment should be installed by a minimum of three experienced installers.
4. WARNING: Do not attempt to assemble or disassemble rail and/or uprights in winds greater than 5MPH.
Parts
Upright (2)
(Part# UZ1361) - 306” overall length
Ground Sleeve Cap (2)
(Part# UZ56)
Post (2)
(Part# UZ1363)
Ground Sleeve (2)
(Part# UZ675)
Rail (1)
(Part# UZ1362) - 208” overall length
***CAUTION***
This goal has been designed to be used for the game of rugby only. Goal posts must be anchored
AT ALL TIMES and shall be secured against overturning. Do not climb on the goal framework at
anytime! All fastenings must be checked to insure they are fully tightened before and after each
use of this product. Goal posts not in use must be disassembled and properly stored in a safe,
secure area. Assembled goal posts should not be left unattended. Do not use this equipment
during the threat of high winds. Goal posts should be checked for safety before and after each
use. All warning and safety labels included with this product must be visible at all times. Any
modifications to this or any Kwik Goal product will void any and all warranties.
140 Pacific Drive Quakertown, PA 18951
(P) 215-536-2200 / (P) 800-531-4252 / (F) 215-536-4309 / (F) 800-778-8869
Visit our website @ kwikgoal.com
2012, Kwik Goal Ltd.
NZ343 Rev. 10/30/12
Hardware
1/2” X 4” Flat Head Screw (Part# TZ218)
1/2” Lock Nut (Part# TZ28)
Assembly Tools
4
4
3/4” Wrench
Flat Head Screwdriver
6’ Level
5. Assemble posts and rail, using 1/2" flat head screws and lock nuts. NOTE: countersunk holes in rail
indicate front face of rail. (This side must face playing field.)
Rail
Post
Post
Countersunk Hole
1/2” Lock Nut
Post
Playing Field
1/2” x 4” Flat Head Screw
Rail
NZ343 Rev. 10/30/12
6. Mark field location for posts.
111-3/4"
(2.83 m)
Center of Goal Line
+
+
Face of goal NOT beyond this point
Post
Post
223-1/2"
(5.66 m)
Playing Field
Post
5“ Below Surface
30
Approx.
Concrete
Ground Sleeve
41 1/4"
10”
Minimum
7. Dig holes a minimum of 51 1/4" deep and 24"
across. Fill bottom of holes with 1” diameter stone
until the hole is 41 1/4" in depth and top of ground
sleeve is 5” below field surface. NOTE: The stone
base allows water and small debris to flow
through the hole located in the bottom of
ground sleeve.
1” diameter
stone for
drainage
24" Minimum
***CAUTION***
This goal has been designed to be used for the game of rugby only. Goal posts must be anchored
AT ALL TIMES and shall be secured against overturning. Do not climb on the goal framework at
anytime! All fastenings must be checked to insure they are fully tightened before and after each
use of this product. Goal posts not in use must be disassembled and properly stored in a safe,
secure area. Assembled goal posts should not be left unattended. Do not use this equipment
during the threat of high winds. Goal posts should be checked for safety before and after each
use. All warning and safety labels included with this product must be visible at all times. Any
modifications to this or any Kwik Goal product will void any and all warranties.
NZ343 Rev. 10/30/12
8. Set assembled goal posts with ground sleeves into holes. Plumb and level goal making sure the bottom
of the rail is 9’-10” (3m) high from the field surface. Face of the goal post should not enter into the playing
field. Seal space between posts and ground sleeves with tape or small bead of sealer. This will stop debris
from entering ground sleeves during construction.
Front View
Post
Post
Field Surface
Concrete
Ground Sleeve
Large Stone
9. Fill holes with concrete, flush to the top of ground sleeves. Be sure to plumb and level posts before
concrete begins to cure. After concrete has fully cured replace field surface over cured concrete and dispose
of excess soil.
***CAUTION***
This goal has been designed to be used for the game of rugby only. Goal posts must be anchored
AT ALL TIMES and shall be secured against overturning. Do not climb on the goal framework at
anytime! All fastenings must be checked to insure they are fully tightened before and after each
use of this product. Goal posts not in use must be disassembled and properly stored in a safe,
secure area. Assembled goal posts should not be left unattended. Do not use this equipment
during the threat of high winds. Goal posts should be checked for safety before and after each
use. All warning and safety labels included with this product must be visible at all times. Any
modifications to this or any Kwik Goal product will void any and all warranties.
NZ343 Rev. 10/30/12
10. After concrete has cured remove goal and attach uprights to goal. NOTE: countersunk holes in
uprights indicate front face of uprights. (This side must face playing field.)
Countersunk Hole
Upright
1/2” Lock Nut
1/2” Flat Head Screw
11. When removing goal from field after initial installation, the rail can be removed before removing goal posts
from ground sleeves. Do this by removing the two 1/2" flat head screws and then sliding rail to one side. Be
sure to cover open ground sleeves with caps to stop debris from entering hole after removing goal posts.
12. After reinstallation be sure to re-seal seam between ground sleeve and goal posts to stop debris from
entering ground sleeves.
***CAUTION***
This goal has been designed to be used for the game of rugby only. Goal posts must be anchored
AT ALL TIMES and shall be secured against overturning. Do not climb on the goal framework at
anytime! All fastenings must be checked to insure they are fully tightened before and after each
use of this product. Goal posts not in use must be disassembled and properly stored in a safe,
secure area. Assembled goal posts should not be left unattended. Do not use this equipment
during the threat of high winds. Goal posts should be checked for safety before and after each
use. All warning and safety labels included with this product must be visible at all times. Any
modifications to this or any Kwik Goal product will void any and all warranties.
NZ343 Rev. 10/30/12