DSP & MPU
ANALOG & MIXED
SIGNALS
Card Emulation Mode (from host):
NFC Forum T4T (ISO/IEC 14443 A&B)
and NCI interface. PN7150 is the new
at 106 kbit/s, NFC Forum T3T (FeliCa)
KEY BENEFITS
•
plug’n play and high performance full
application, especially those with OS
NFC solution from NXP, in addition to
systems
Flexible host interface
•
controller with embedded firmware and
Plug-and-play NFC operation with
many platforms, including most LPC,
NCI interface, takes designs to the next
•
Supply voltage: 1.8 to 3.3 V
level, with the addition of higher output
•
I2C interface: 3.4 Mbit/s
power, for longer reading distance
•
NCI 1.0-compliant protocol
and smaller antenna size, as well as
•
IRQ signal for improved
standard HVQFN40 package, for lower-
synchronization
Kinetis and i.MX boards
•
All typical NFC use cases, including
pairing, personalization, extended user
interface, maintenance, etc.
•
cost manufacturing. Optimized for fast
Fast deployment of advanced, fully
interoperable NFC functionality, with a
design-in, PN7150 is accompanied by
lower overall cost.
Linux, Android, and WinIoT drivers, and
Complete, power-efficient NFC
support the most popular platforms,
control
including Raspberry Pi, BeagleBone
RF driver: 3.0 to 4.75 V, 180 mA max
•
NFC Forum device requirement: v1.3
LPCXpresso, i.MX boards, etc.).
•
Fully configurable polling loop with
•
Gateways, routers
low-power mode
•
Set-top boxes
•
Load modulation scheme: active
•
Audio
•
Standard packages: HVQFN40
•
Home appliances
•
Healthcare/Medical
•
Accessories
Full HW and SW compatibility
•
PROGR. LOGIC & INTERFACE
•
an Arduino compatible header (Kinetis,
POWER MANAGEMENT
APPLICATION EXAMPLES
Black as well as any boards featuring
KEY FEATURES
Support for Linux, Android, Windows
IoT, RTOS, NullOS
•
OPTOELECTRONICS
the well-established PN7120. This NFC
Seamless integration of NFC into any
MEMORY
•
solution with integrated firmware
POWER DISCR. & MODULES
PN7150 is a full NFC controller
MCU & PERIPHERALS
EBV INTRODUCES PN7150
Plug’n Play High Performance Full NFC
Solution
Interface to RasperryPi, BeagleBone
Black, and all boards with Arduino-
SENSOR
compatible header
All NFC operating modes
•
Read/Write Mode: ISO/IEC 14443
& 424 kbit/s, MIFARE 1K, 4K, NFC
OM5578_PN7150_Arduinokit
WIRED COMM.
A&B up to 848 kbit/s, FeliCa at 212
EBV presents OM5578
Forum type 1, 2, 3, 4, 5 tags, ISO/IEC
15693
All Peer-to-Peer Modes
1
WIRELESS COMM.
•