Activate
Rider
Calibration
What is Rider Calibration?
This feature enables a rider to calibrate the Watt sensor
before every ride, quickly and easily. This is the best way to
ensure the most consistent wattage and speed/distance
readings for the MPower console.
This is how to turn Rider Calibration ON/OFF
1. Enter service
2. Push Light
mode and scroll
to the Calibrate
menu option
button, display
will flash “UP”
and the result
of the previous
calibration
below
“CALIBRATE”
3. Push Avg/End button
until middle display is
flashing “RIDER” under
“CALIBRATE” and below that
will be current setting
ON/OFF
4. Push Light button, display will
read “RIDER CALIBRATE” and
flash current setting
5. Push Avg/End button to
change between ON/OFF and
push Light button to make
selection
2.Push Light button
3. Hold down red brake
knob and stop pedaling
4. Release brake knob
1. Push any button to
turn on console and
pedal slowly
Rider
Calibration
5. Turn brake knob
counter-clockwise until it
stops, then push Light
button to start calibration
7. Ride
6. Wait
V2
Service
Menu
Calibration
NOTE: this is how to calibrate the v2 console if Rider
Calibration is turned OFF. See Rider Calibration
instructions for more information on that feature.
If Rider Calibration is turned OFF, this is the required last
step when setting up a console for the first time, or when
changing batteries in the Watt sensor.
1. Ensure sensors on and functioning
--Turn on console by pushing any button
and spin the wheel at least one
revolution
--The Watts display window will start with
a display of dashes “- - -“
--Push down on brake knob and hold until
the Watts display window changes
from dashes to a number (such as 0)
Once a number
shows in the
Watts window,
spin the wheel
and watch for a
Watts > 0.
When you see
Watts > 0, stop
pedals and
continue
2. Enter
3. Push Light
4. Push
service
mode and
scroll to
the
Calibrate
menu
option
button,
display will
flash “UP”
and the
result of the
previous
calibration
below
“CALIBRATE”
Light
button,
display will
read
“RAISE
BRAKE
THEN PUSH
LIGHT TO
CAL”
5. Double check that you
have raised brake
completely UP (counter
clockwise)
Push Light button to start
calibration – Timer will
start to count down
What Will Happen:
After several seconds display
will read “PASS”
--If timer counts to 0 and result
is “FAIL”, push Light button to
start Calibration again
--If result is “FAIL” several
times, exit service menu and
re-start from Step 1