How to Enable a DMP for Touch Screen Control
Revised: May 1, 2015
Software Release: 3.1.0-787 and Later Releases
Quick Facts
This task note describes how to configure touch screen controller support on DMPs in Cisco StadiumVision
Director.
Note
Touch screen control is only supported on the Cisco DMP 4310G.
•
Cisco StadiumVision Director supports a limited number of touch screen drivers for the Cisco DMP
4310G. To ensure compatibility of your devices, contact your Cisco Systems sales representative.
•
Touch screen controller support requires a Cisco DMP 4310G running a minimum of Cisco DMS
version 5.4.
•
Calibration only needs to be performed once per DMP unless you change the display device make
or model.
Americas Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
How to Enable a DMP for Touch Screen Control
Task
Task
To enable a DMP for touch screen control, complete the following steps:
Action
Step 1
Step 2
Log into Cisco StadiumVision Director with an administrator account.
To configure the display controller device, do the following:
a.
Go to Control Panel > Setup > Devices > Display Specifications.
b. Click plus (+) icon to add a device.
c. In the Basic Info panel, specify:
– Device name, Make, Model
– Touch Screen Type
d.
Click Save.
Note
Step 3
This configuration is sent to the DMP when you run Initialize Touch Screen for the DMP from the
Management Dashboard.
Go to the Management Dashboard.
Step 4
Under the DMP and TV Controls drawer, go to DMP Install > Initialize Touch Screen.
2
How to Enable a DMP for Touch Screen Control
Task
Action
Step 5
In the Select Devices box, select the DMP(s) where you want to enable touch screen support.
Step 6
Click the Play icon to initialize the selected DMPs.
The display specifications from the Control Panel are sent to the DMP and the selected DMP(s) reboot.
Step 7
To calibrate the touch screens for the selected DMPs, select Show Calibration.
Step 8
Click the Play icon to calibrate the touch screen displays associated with the selected DMPs.
A calibration screen appears on the TV display.
Step 9
Follow the instructions on the TV display, and touch the crosshairs to calibrate the controller.
Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of
Cisco trademarks, go to this URL: www.cisco.com/go/trademarks. Third-party trademarks mentioned are the property of their respective owners. The
use of the word partner does not imply a partnership relationship between Cisco and any other company. (1110R)
Any Internet Protocol (IP) addresses and phone numbers used in this document are not intended to be actual addresses and phone numbers. Any
examples, command display output, network topology diagrams, and other figures included in the document are shown for illustrative purposes only.
Any use of actual IP addresses or phone numbers in illustrative content is unintentional and coincidental.
© 2013 - 2015 Cisco Systems, Inc. All rights reserved.
3
How to Enable a DMP for Touch Screen Control
Task
4