acta mechanica et automatica, vol.10 no.1 (2016)
CONTENTS
Sebastian Faszynka, Janusz Lewandowski, Dariusz Rozumek
Numerical Analysis of Stress and Strain in Specimens with Rectangular Cross-Section
Subjected to Torsion and Bending with Torsion .............................................................................................................................
5
Przemysław Stasiuk, Aleksander Karolczuk, Wiesław Kuczko
Analysis of Correlation between Stresses and Fatigue Lives of Welded Steel Specimens Based
on Real Three-Dimensional Weld Geometry ..................................................................................................................................
12
Andrzej Wróbel, Marek Płaczek, Andrzej Buchacz
Testing of Composite Panels Used as Components of a Freight Wagon by Thermovision ...........................................................
17
Adam Lipski
Accelerated Determination of Fatigue Limit and S-N Curve by Means of Thermographic Method for X5CrNi18-10 Steel ............
22
Sławomir Romaniuk, Zdzisław Gosiewski, Leszek Ambroziak
A Ground Control Station for the UAV Flight Simulator ..................................................................................................................
28
Viorel Ungureanu, Maria Kotełko, Jan Grudziecki
Plastic Mechanisms for Thin-Walled Cold-Formed Steel Members in Eccentric Compression ......................................................
33
Alexander Schrek, Veronika Gajdošová, Pavol Švec
Deformation Properties of Tailor Welded Blank Made of Dual Phase Steels .................................................................................
38
Waldemar Kołodziejczyk
Some Considerations on an Underwater Robotic Manipulator Subjected to the Environmental Disturbances
Caused by Water Current ...............................................................................................................................................................
43
Anna Walicka, Edward Walicki
Thrust Porous Bearing with Rough Surfaces Lubricated by a Rotem-Shinnar Fluid ......................................................................
50
Łukasz Bohdal
Application of a SPH Coupled FEM Method for Simulation of Trimming of Aluminum Autobody Sheet ........................................
56
Anna Kulesa, Andrzej Kurek, Tadeusz Łagoda, Henryk Achtelik, Krzysztof Kluger
Low Cycle Fatigue of Steel in Strain Controled Cyclic Bending .....................................................................................................
62
Heorhiy Sulym, Iaroslav Pasternak, Mykhailo Tomashivskyy
Boundary Integral Equations for an Anisotropic Bimaterial with Thermally Imperfect Interface and Internal Inhomogeneities ......
66
Abstracts .........................................................................................................................................................................................
75
3