A P P E N D I X
C
Supported MIBs
This appendix lists the Simple Network Management Protocol (SNMP) Management Information Bases
(MIBs) that the access point supports for this software release. The Cisco IOS SNMP agent supports both
SNMPv1 and SNMPv2. This appendix contains these sections:
•
MIB List, page C-1
•
Using FTP to Access the MIB Files, page C-2
•
IEEE802dot11-MIB
•
Q-BRIDGE-MIB
•
P-BRIDGE-MIB
•
CISCO-DOT11-IF-MIB
•
CISCO-WLAN-VLAN-MIB
•
CISCO-IETF-DOT11-QOS-MIB
•
CISCO-IETF-DOT11-QOS-EXT-MIB
•
CISCO-DOT11-ASSOCIATION-MIB
•
CISCO-DOT11-QOS-MIB
•
CISCO-DOT11-SSID-SECURITY-MIB
•
CISCO-L2-DEV-MONITORING-MIB
•
CISCO-IP-PROTOCOL-FILTER-MIB
•
CISCO-SYSLOG-EVENT-EXT-MIB
•
CISCO-TBRIDGE-DEV-IF-MIB
•
BRIDGE-MIB
•
CISCO-CDP-MIB
•
CISCO-CONFIG-COPY-MIB
•
CISCO-CONFIG-MAN-MIB
•
CISCO-FLASH-MIB
•
CISCO-IMAGE-MIB
MIB List
Cisco Wireless ISR and HWIC Access Point Configuration Guide
OL-6415-04
C-1
Appendix C
Supported MIBs
Using FTP to Access the MIB Files
•
CISCO-MEMORY-POOL-MIB
•
CISCO-PROCESS-MIB
•
CISCO-PRODUCTS-MIB
•
CISCO-SMI-MIB
•
CISCO-TC-MIB
•
CISCO-SYSLOG-MIB
•
ENTITY-MIB
•
IF-MIB
•
OLD-CISCO-CHASSIS-MIB
•
OLD-CISCO-SYS-MIB
•
OLD-CISCO-SYSTEM-MIB
•
OLD-CISCO-TS-MIB
•
RFC1213-MIB
•
RFC1398-MIB
•
SNMPv2-MIB
•
SNMPv2-SMI
•
SNMPv2-TC
Using FTP to Access the MIB Files
Follow these steps to obtain each MIB file by using FTP:
Step 1
Use FTP to access the server ftp.cisco.com.
Step 2
Log in with the username anonymous.
Step 3
Enter your e-mail username when prompted for the password.
Step 4
At the ftp> prompt, change directories to /pub/mibs/v1 or /pub/mibs/v2.
Step 5
Use the get MIB_filename command to obtain a copy of the MIB file.
Note
You can also access information about MIBs on the Cisco web site:
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml
Cisco Wireless ISR and HWIC Access Point Configuration Guide
C-2
OL-6415-04