ENGR 2
Assignment 5
Ex 6-2 Draw a complete front view of the object and a sectional view. The cutting plane line should be
added to the front view along the vertical centerline of the object. TYPO: change D15 to D55
Ex 6-8 is a sketching exercise. Draw the object (front view ) on grid paper and replace the side view with
an appropriate section view. Use a straight edge to hatch the solid areas. Add a cutting plane line to the
front view.
EX 6-17 Draw the top orthographic view and the indicated sectional view
TYPO: change 1.25 to 1.125.
MAKE VERTICAL HEIGHT of bracket = 1.5
From side view, small circle center is .31 from top, .31 from left side
Square cutout extends down the same distance it extends in to the top surface
Ex 6-32 Redraw the given views and add the specified sectional view