ULTRASTAB 867-200I INSTALLATION
User Side
Normal Operation => ON-state
D-SUB-9
DF DWG. No. 88961
6
6
White
Current Output (+/- 200mA)
1
1
Brown
Current Return
9
9
Green
+ 15 V ( +/- 5% )
Yellow
OPTO-ISOLATOR
5
5
Gray
- 15 V ( +/- 5% )
4
4
Pink
GND
8
Blue
Status ( max. 30mA )
3
Red
Status ( max. 30mA )
BC847
10K
n.c. 7
7
n.c. 2
2
Shield
Electrostatic shield
Ground
Pin configuration for 9 pole D_SUB :
Pin 1 Current return
Pin 2 N.C.
Pin 3 Normal operation status
Pin 4 GND
Pin 5 -15V supply voltage
Pin 6
Pin 7
Pin 8
Pin 9
House
Current output
N.C.
Normal operation status
+15V supply voltage
Electrostatic shield
Electrical specification - power :
Supply voltage pin 9 to pin 4
Supply voltage pin 5 to pin 4
Supply current pin 9 to pin 4
Supply current pin 5 to pin 4
Test voltage secondary (pin 4) to shield
:
:
:
:
:
+ 15 V +/- 5 %
- 15 V +/- 5 %
+ 70 mA + output current ( 200 mA nom. )
- 70 mA - output current ( 200 mA nom. )
200 VDC
Electrical specification – status signal :
Fault level ( off-state )
Max. voltage pin 8 to pin 3 , off-state
Max. current pin 8 to pin 3 , on-state
Reverse voltage pin 8 to pin 3 , off-state
On-voltage pin 8 to pin 3 , I = 5 mA
Test voltage secondary (pin 4) to pin 8
:
:
:
:
:
:
Ip > 110 %
45 V
30 mA
5V
1 V max.
300 VDC
Accessories :
• 9 pole D-sub plug with 2m shielded cable ( Part No. 65889610 )
• 5 Ω Burden Resistor ( 2 x 10 Ω ) , 0.05% , Tc < 3 ppm/°C
• Ø 25mm busbar
DANFYSIK A/S ⋅ DK-4040 Jyllinge ⋅ Denmark ⋅ Tel.: +45 46 79 00 00 ⋅ Fax: +45 46 79 00 01
Web: www.danfysik.dk – e-mail: [email protected]
1
09A04