Code Cube Constructor
Print out the sheets, then follow the steps below. Kids, ask a grown-up for help!
1
2
Cut the pieces of paper along the
dotted lines to make 6 squares.
5
3
Fold each of the 6 squares in half,
then unfold them.
6
Open flaps at right angles.
9
Fold the sides to the middle.
7
Repeat steps 3-5 with the
remaining sheets of paper.
10
Repeat step 8 on the
opposite side of the cube.
Use Parental Controls to restrict 3D mode for children 6 and under.
4
© 2016 HAL Laboratory, Inc. / Nintendo. Kirby is a trademark of Nintendo. © 2016 Nintendo.
8
Lay a piece on a flat surface,
then stand a piece on top of it.
11
Repeat step 7 on the
opposite side of the cube.
Turn the piece lengthwise and
fold the sides to the middle.
Slide the final piece into place, making
sure no flaps are on the outside.
Slide in another piece,
making sure the flaps go inside.
12
Your Code Cube is complete.
Nice job!
Fold this in first
Fold this in first
Fold this in first
Fold this in first
Fold this in first
Fold this in first
Fold this in first
Fold this in first
Fold this in first
Fold this in first
© 2016 HAL Laboratory, Inc. / Nintendo. Kirby is a trademark of Nintendo. © 2016 Nintendo.
Fold this in first
Fold this in first
Use Parental Controls to restrict 3D mode for children 6 and under.