OPERATION
BLUETOOTH (information)
For ‘Watcher’ operation, refer to tablet mapping on opposite side of this document.
The ‘Watcher’ tablet may already be pre-paired to the target
instrument.
1) Switch ON ‘Watcher’ tablet.
To change, or add another instrument during start-up, do the
following:
2) Switch ON Instrument.
Note: Instrument will not begin warm-up until connected to ‘Watcher’
tablet.
1) Select
3) Open GMI ‘Watcher’ App
4) Select instrument serial number on ‘Watcher’ tablet pop-up window,
> Settings > Bluetooth >
2) Select instrument serial number, e.g. GMI XXXXXX or,
Find devices nearby.
3) Use pairing password ‘0’
as shown:
4) Open GMI ‘Watcher’ App
5) Instrument warms-up. During this time, you can select ‘Cal-Due’ or
‘Zero Fault’ warning messages on the ‘Watcher’ tablet to send to
the instrument.
5) Select new instrument from list.
6) ‘Watcher’ tablet is now ready for training.
Document Part Number: 43632 Issue 3 (04/07/2013)
43632_03.pmd
GMI Head Office:
USA Head Office (Detcon):
GMI Service & Calibration Division:
Inchinnan Business Park,
Renfrew,
PA4 9RG,
Scotland, U.K.
Telephone +44 (0)141 812 3211
Fax +44 (0)141 812 7820
e-mail: [email protected]
http://www.gmiuk.com
4055 Technology Forest Blvd.,
Suite 100, The Woodlands,
TX 77381,
USA
Telephone (713) 559 9290
Toll Free (877) 421 5315
Fax 281 292 2860
e-mail: [email protected]
25 Cochran Close, Crownhill,
Milton Keynes,
MK8 OAJ,
England, U.K.
Telephone +44 (0)1908 568867
Fax +44 (0)1908 261056
e-mail: [email protected]
1
7/4/2013, 12:17 PM
CONNECTION STATUS
Green = Connected
Red = Disconnected
INSTRUMENT MODE SELECTED
CURRENT RANGE
TARGET VALUE
INSTRUMENT READING
1
SELECT RANGE
<
2 SELECT VALUE
Slide to send
consecutive values
<
TRIM TO EXACT VALUE
Tap + or Hold to increment / decrement
SEND SAMPLE FAULT
TO INSTRUMENT
SEND 'ZERO CHECK' and
'ZERO FAULTS' TO INSTRUMENT.
(only active during instrument warm-up)
SEND BAT & BAT FAULTS
TO INSTRUMENT
SEND CAL DUE & SER DUE
WARNINGS TO INSTRUMENT
(only active during instrument warm-up)
EXIT
43632_03.pmd
2
7/4/2013, 12:17 PM