Fibreglass Surface Prep
PRODUCT DESCRIPTION
Fibreglass Surface Prep is a mould release agent
remover, which precludes the need for sanding
bare GRP when used with International's No Sand
Primer. Fibreglass Surface Prep thoroughly
cleans the gelcoat and provides a key for
Fibreglass No Sand Primer to be applied.
Fibreglass Surface Prep can also be used to
prepare aged and weathered alkyds prior to
application of subsequent coats by softening the
surface slightly.
KEY FEATURES AND BENEFITS
•
Fibreglass Surface Prep thoroughly cleans and degreases the gelcoat, removing all waxes
and possible mould.
•
Fibreglass Surface Prep abrades, cleans and softens old alkyds promoting adhesion of
subsequent coats.
•
Easy application with a cloth or sponge creates a good key on the gelcoat surface, while
avoiding dust and noise created through abrasion with sand paper.
•
The tinted colour of Fibreglass Surface Prep ensures it is easy to see where the product
has been applied to white gelcoat, and makes it difficult to miss areas unintentionally.
SYSTEMS AND COMPATIBILITY
Suitable for use on GRP only.
PRODUCT DATA
AREA
METHODS OF APPLICATION
AVAILABLE SHADES
PACK SIZE
Typical Shelf Life
Refer to Fibreglass Surface Prep product data sheet for more information
Always read the Health & Safety precautions on the label prior to use
Above and below the waterline
Cloth / Sponge
YMA601 – Pink
2.5Lt
2 years
SURFACE PREPARATIONS AND SYSTEMS
Apply Fibreglass Surface Prep to a damp cloth or sponge, then wipe the whole surface to be cleaned using
moderate pressure. Wipe off with a clean, wet, cloth ensuring no traces of Fibreglass Surface Prep remain.
As soon as the surface is dry, it is ready to paint.
BARE GRP: If the overcoating time exceeds 4 hours, ensure that the surface is clean and dry prior to
application of the paint.
ALKYDS: If the overcoating time exceeds 4 hours, re-apply Fibreglass Surface Prep prior to subsequent
overcoating.
CAUTION: Protect from frost.
Fibreglass Surface Prep will not remove serious blemishes.
OVERCOATING TIMES:
10°C
Overcoated By:
Min
15°C
Max
Min
23°C
Max
Min
35°C
Max
Min
Max
RELATED PRODUCTS
PRODUCT CODE
DESCRIPTION
YPA140 / YPA 142
Fibreglass No Sand Primer
June 2002
International Coatings Ltd., 24-30 Canute Road, Southampton.
Tel: 023 8022 6722 Fax: 023 8033 5975
® and International ® are registered trademarks of International Coatings Ltd.
Akzo Nobel Logo is a registered trademark of Akzo Nobel NV.
Teflon is a registered trademark of DuPont.
Disclaimer The information given in this sheet is not intended to be exhaustive. Any person using the product without first making further enquiries as to the suitability
of the product for the intended purpose does so at their own risk and we can accept no responsibility for the performance of the product or for any loss or damage
(other than death or personal injury resulting from negligence) arising out of such use. The information contained in this sheet is liable to modification from time to time
in the light of experience and our policy of continuous product development.